Maintenance And Storage - Ribimex PRPMV1/M Manuel D'instructions Et D'utilisation

• Gently place the tool on the workpiece surface.
• Avoid contact with foreign objects (such as metal screws and nails) during operation.
• Do not allow the sandpaper to wear away, replace it as needed.
Scraping operation
• Install the scraper blade (8) onto the tool. Example application: removing vinyl, vernish,
paint layers, carpet, caulk and adhesives.
• Hold the machine with both hands in a stable position, then switch on the machine without
loading for few seconds.
• Adjust the speed of the tool with scrolling the speed dial (4).
• Gently place the tool on the workpiece surface at an angle of 10-15°.
• If the substance is strong adhesive, grease the scraper blade to reduce gumming up.
• If you need to work on a delicate surface, use masking tape to protect the surface.
After use
• Remove the tool from the workpiece surface, then switch off the tool.
5.3- Tips
• Secure the workpiece with suitable clamping devices.
• Do not apply excessive pressure on the tool. Allow the tool to do the work.
• Stop the machine immediately in case of abnormal vibration or noise.
• Avoid prolong usage at low speed. If the tool becomes too hot, especially when used at low
speed, set the speed to maximum and run without load for 2 minutes to allow the motor cool
down.
• Always keep the blade sharp.
• In case of uncertainty behind the object, use suitable detectors to find concealed power lines
before sawing.
VI. MAINTENANCE AND STORAGE
WARNING!
Before any intervention on product, ensure that power is set to the "0" position
and disconnect from main power source.
Reminder: In order to maintain the machine in good working condition, carry out regular
maintenance of the machine after each use and before storage. Any breach or inadequate
maintenance reduces the life of the machine and increases the risk of breakdowns and accidents.
6.1- Cleaning
• Before cleaning, turn off the tool and disconnect from power source.
• Clean the machine with a dry clean cloth. Do not use water, solvent or detergent for
cleaning.
• Never immerse the machine in water or any liquids.
• Always keep the ventilation holes clean.
6.2- Storage
• Clean the product before storage.
• Keep product, instruction manual and accessories (if any) in the original packaging.
• Store the product in a clean environment, where is not freezing or too hot (exceed 50 ̊ C ).
• Keep out of reach of children (e.g. lock it up).
Page 13 / 21