Getting Started - Ribimex PRPMV1/M Manuel D'instructions Et D'utilisation

• Ensure the accessory is correct and sharp before starting the tool.
• Never hold the work pieces with your hand or any part of your body during operations with
the tool.
• Keep hands and your body parts away from any moving parts and blade.
• Disconnect the tool from the power source before making any adjustments and changing
accessories.
• This tool vibrates during use. Continual and regular users should monitor closely the
condition of their hands and fingers. Prolong exposure to vibration could result in
whitefinger disease (Raynaud's phenomenon) or carpal tunnel syndrome. If any of the above
symptoms appear, seek medical advice immediately.
• Wear suitable anti-vibration gloves when using the tool.
• Plan your work and allow plenty of time for rest.
• Hold the tool by insulated gripping surface, when performing an operation where the cutting
accessory may contact hidden wiring or its own cord.
• Do not apply the tool on any moistened materials (such as wallpaper). The penetration of
moisture into the power tool increases the risk of electric shock.
IV. GETTING STARTED
4.1- Unpacking
• Remove the product from packaging.
• Check if the product and accessories (if any) are intact.
4.2- Content
• 1 oscillating multi-tool body
• 1 straight saw blade
• 1 hook and loop sanding pad
• 3 sandpapers
• 1 scraper blade
• 1 instruction manual
4.3- Assembly
WARNING!
Before starting assembly or changing accessories, turn it off and disconnect from
main power source.
Install/remove accessories
• All accessories should be installed on the tool in a similar manner.
• Flip the accessory change lever (1) completely to loosen the accessory holder (2).
• Insert an accessory into the accessory holder from the open-end. Make sure the alignment
holes on the accessory match the position of pins on the accessory holder.
• Flip the accessory change lever completely to tighten the accessory holder.
• Check and make sure the accessory is securely positioned onto the tool before starting the
tool.
• To remove the accessory, completely flip the accessory change lever again, then release the
accessory from the tool.
Page 11 / 21