Ribimex PRPMV1/M Manuel D'instructions Et D'utilisation page 12

Install/remove sandpaper
• Install the hook and loop sanding pad (6) to the tool.
• Place a sandpaper (7) onto the sanding pad and make sure they are aligned.
• Firmly press the sandpaper against the sanding pad.
• To remove the sandpaper, simply peel it away from the pad.
4.4- Switch On/Off
• Connect the tool to the main power source.
• To switch the tool on, set the power switch (5) to "1" position.
• To switch the tool off, set the power switch to "0" position.
4.5- Speed control
• The oscillating speed can be adjusted between 12000 and 20000 per minute by scrolling the
speed control dial (4).
V. OPERATION
5.1- Intended use
This power tool is intended for indoor domestic use. This is designed for sawing and
remodelling wooden materials, plastic, non-ferrous metals and fasteners (such as nails and
clamps), as well as soft wall tiles and small surface dry sanding. Do not use on materials
containing asbestos or other hazardous materials. The tool is not intended for artisanal,
commercial, professional and / or industrial use.
5.2- Operation
Before use
• Check the accessory is securely seated on the tool with holes and pins aligned.
• Before connecting the tool to the main sources, make sure the power switch (5) was set at
"0" position.
Cutting operation
• Use straight saw blade (3) for making precise cuts on wood, plastic or drywall material.
Example application: cutting openings for electric boxes, repairing flooring, cutting flooring
for venting and more.
• Hold the machine with both hands in a stable position, then switch on the machine without
loading for few seconds.
• Adjust the speed of the tool with scrolling the speed dial (4).
• If you need to rest the blade on a delicate surface, use cardboard or masking tape to protect
the surface.
• Gently place the tool on the workpiece surface.
• Maintain slight pendulum motion when plunge cutting.
Sanding operation
• Install the sanding accessory (6 & 7) onto the tool with selecting suitable sandpaper.
Example application: dry sanding of wood, plastic and metal surfaces, especially in corners,
edges and hard to reach areas.
• Hold the machine with both hands in a stable position, then switch on the machine without
loading for few seconds.
• Adjust the speed of the tool with scrolling the speed dial (4).
Page 12 / 21