Part Names; Front Panel - Pioneer FS-W40 Mode D'emploi

> Before Start > Part Names

Front Panel

Part Names

1. Remote control sensor
2. Display ( P6)
3. Í/l button: Turns the unit on or into standby mode.
4. VOLUME button: Allows you to adjust the volume. These buttons also cancel muting.
5. ON indicator: This lights blue when the power is on and goes out when the unit switches
to standby. It lights red if the unit enters standby mode when the features are enabled that
continue to work when this unit is in standby, such as HDMI Standby Through and
Wireless Speaker Standby.
6. NETWORK indicator: This lights blue when network features are being used. It will flash if
the connection to the network is not correct.
7. DIMMER button: You can switch the display off or adjust the brightness of the display in
three steps.
8. INPUT button: Switches the input to be played. (BD/DVD / CBL/SAT / GAME /
STRM BOX / DIGITAL IN / ANALOG IN / TV / FM / NET / USB / BT AUDIO)
> Install > Setup
 

> Playback
Supplementary information | Firmware Update | Others

 


E
N
3