Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

S-FCRW4500
S-FCW4550
WHAT'S IN THE BOX
• Front speakers x 2
• Center speaker x 1
• Surround speakers x 2*
• Speaker cords:
Red/White (Front speakers) 5m x 2
Green (Center speaker) 5m x 1
Blue/Grey (Surround speakers) 10m x 2*
Purple (Subwoofer) x 1
• Non-skid pads x 20 (S-FCRW4500)
• Non-skid pads x 12 (S-FCRW4550)
• Adhesive strips x 4 (S-FCRW4550 only)
• Operating guide
* S-FCRW4500 only
IMPORTANT:
The S-FCW4550 speaker system does not include surround
speakers. References to surround speakers in the following
instructions apply only to the S-FCRW4500 speaker system.
The serial number for this equipment is located on the rear of
the subwoofer. Please write this serial number on the warranty
page and keep it in a secure area for future reference.
BEFORE USE
Thank you for buying this Pioneer product.
Please read through this operating guide before using your
speaker system to optimize performance.
FRONT / CENTER / SURROUND SPEAKERS
In order to prevent damage to the speaker system resulting
from input overload, please observe the following precau-
tions:
Do not supply signal to the speaker system in excess of the
maximum permissible input.
When connecting or disconnecting cables, be sure amplifier
power is OFF.
Do not use excessive amplifier volume if using a tone control
to emphasize high or low frequencies.
INSTALLATION PRECAUTIONS
FRONT / CENTER / SPEAKERS
Do not install these units near a stove or other heating
appliance, or put them in a place exposed to the sun. Such
locations may cause the cabinet to change color and the
speaker system to break down.
The front and center speakers supplied with this
system are magnetically shielded. However, placing
them extremely close to a television may result in color
distortion on the screen. If this happens, move the
speakers a little further away and switch off the
television for 15-30 minutes.
• Front speaker stand bases x 2
• Front speaker stand stems x 2
SURROUND SPEAKERS
If mounting to walls, examine them to confirm that their
strength is sufficient to bear the weight of the speaker system.
This system i s not provided with any hardware for installa-
tion, so select suitable components corresponding to the
construction of your walls.
If you are unsure of the quality and strength of the walls,
consult a professional for advice.
The surround speakers supplied with this system are
magnetically shielded. However, placing them
extremely close to a television may result in color
distortion on the screen. If this happens, move the
speakers a little further away and switch off the
television for 15-30 minutes.
SUBWOOFER
Do not place anything on top of the cabinet.
Do not spill liquid on the cabinet.
Place the subwoofer at least 8 inches from any wall or curtain
in order to avoid heat build-up.
The subwoofer is not magnetically shielded and so
should not be placed near a TV or monitor. Magnetic
storage media (such as floppy discs and tape or video
cassettes) should also not be kept close to the subwoofer.
CAUTION:
Do not connect any of the supplied speakers to any
other amplifier. This may result in malfunction or fire.
Do not fix the subwoofer, front and center speakers to the
wall or ceiling; they could cause injury if they fell.
Pioneer will not be responsible for any accidents or damage
that may result from improper installation.
WARNING:
Handling the cord on this product or cords associated with
accessories sold with the product will expose you to lead, a
chemical known to the State of California and other
governmental entities to cause cancer and birth defects
or other reproductive harm.
WASH HANDS AFTER HANDLING.
www.pioneerelectronics.com
OPERATING GUIDE
HOME THEATER
LOUDSPEAKER SYSTEM
Front speaker covers x 2*
• Surround speaker bases x 2*
• Small screws x 8
• Large screws x 4
Subwoofer
1

Publicité

Table des Matières
loading

Sommaire des Matières pour Pioneer S-FCRW4500

  • Page 1 Such wall or ceiling; they could cause injury if they fell. locations may cause the cabinet to change color and the Pioneer will not be responsible for any accidents or damage • speaker system to break down.
  • Page 2: Safety Precautions When Setting Up

    Using four small screws for each speaker stand, secure the base to the stem as shown in the illustrations below. Make sure the Pioneer logo on the stem is facing forward, and the outlet on the base (for the speaker cord) is towards the back.
  • Page 3: Center Speaker

    Standard surround 5-spot setup (S-FCRW4500 only) 3. Secure the speaker to the speaker stand with the screws This is a standard multichannel surround soundspeaker setup provided. for optimal 5.1 channel home theatre sound. Using two large screws for each speaker stand, secure the speaker to the speaker stand as shown in the illustration below.
  • Page 4: Listening Position

    4. Connect the speaker system. Front surround 3-spot setup (S-FCRW4500 only) Refer to the setup guide provided to connect the speakers This setup is ideal when rear surround speaker placement isn’t properly. After connecting the speaker wires, thread the front...
  • Page 5: Important

    www.pioneerelectronics.com CONNECTING YOUR SYSTEM After connecting the speaker wires to the surround speakers, use the groove provided to secure the speaker wire as shown at left. Leave 10cm of slack from the speaker terminals so the upper IMPORTANT: (surround) speaker can turn freely. Make sure all equipment is turned off before making any When you're finished, thread the surround speaker cords through connections.
  • Page 6 www.pioneerelectronics.com TROUBLESHOOTING SYMPTOM PROBABLE CAUSE REMEDY 1. No sound • Bad speaker wire or connection • Connect correctly or replace wire • Receiver is off • Turn on receiver • Volume control is at zero • Slowly turn up volume 2.
  • Page 7 7 1/2 (W) x 14 3/16 (H) x 12 7/8 (D) in. Weight ............5.0 kg/ 11 lb. 1 oz Note: Specifications and design subject to possible modification without notice due to improvements. Published by Pioneer Corporation. Copyright © 2005 Pioneer Corporation. All rights reserved.
  • Page 8: Contenu De L'emballage

    Dans ce cas, écartez davantage les haut-parleurs et mettez le téléviseur hors tension pendant 15 à 30 minutes. • Merci de votre achat de cet appareil Pioneer. • Veuillez lire attentivement ce mode d’emploi avant d’utiliser CAISSON DE BASSE ces enceintes acoustiques, afin d’en obtenir des...
  • Page 9: Précautions De Sécurité À L'installation

    Au moyen de 4 vis pour chaque haut-parleur, fixez la base sur la tige comme indiqué sur les illustrations ci-dessous. Assurez-vous que le logo Pioneer sur la tige soit dirigé vers l’avant et que la sortie prévue sur la base pour le cordon du haut-parleur soit dirigée vers l’arrière.
  • Page 10 3. Immobilisez le haut-parleur sur son support au moyen Agencement standard en 5 points des vis fournies. (S-FCRW4500 seulement) Utilisez deux grandes vis pour chaque support de haut-parleur et immobilisez le haut-parleur sur son support comme indiqué Voici l’agencement habituel des haut-parleurs d’ambiance sur l’illustration ci-dessus.
  • Page 11 4. Raccordez les enceintes acoustiques. Agencement haut-parleurs d’ambiance Reportez-vous au guide d’installation fourni pour raccorder avant en 3 points (S-FCRW4500 seulement) correctement les haut-parleurs. Une fois que les fils sont branchés, faites passer le cordon du haut-parleur avant par Cet agencement est idéal s’il n’est pas possible de placer les l’orifice prévu dans la base du support comme illustré...
  • Page 12: Branchement Du Système

    www.pioneerelectronics.com Après avoir branché les fils de haut-parleur sur les haut- BRANCHEMENT DU SYSTÈME parleurs d’ambiance, utilisez la rainure prévue pour immobiliser le fil de haut-parleur comme illustré à gauche. Prévoyez un mou IMPORTANT : de 10 cm à partir des bornes de haut-parleur de sorte que le haut-parleur supérieur (d’ambiance) puisse tourner librement.
  • Page 13: Guide De Dépannage

    www.pioneerelectronics.com GUIDE DE DÉPANNAGE SYMPTÔME CAUSE PROBABLE CORRECTION 1. Absence de son • Fil de haut-parleur endommagé ou • Connectez correctement ou remplacez le connexion erronée. fil. • L’ampli-tuner est hors tension. • Mettez l’ampli-tuner sous tension. • La commande de volume est réglée sur •...
  • Page 14: Fiche Technique

    Dimensions ........190 x 360 x 327 mm (LxHxP) Poids ................. 5,0 kg Remarque : Spécifications et design sous réserve de changements sans préavis en raison d’améliorations éventuelles. Publication de Pioneer Corporation. © 2005 Pioneer Corporation. Tous droits de reproduction et de traduction reserves.
  • Page 15 WARRANTY PERIOD For the period specified below from date of original retail purchase (the warranty period) from an authorized Pioneer dealer, Pioneer Electronics (USA) Inc. (PUSA), and Pioneer Electronics of Canada, Inc. (POC) warrants that products distributed by PUSA in the U.S.A., and by POC in Canada that fail to function properly under normal use due to a manufacturing defect when installed and...

Ce manuel est également adapté pour:

S-fcw4550

Table des Matières