mspa Elite E-BA04 BAIKAL Manuel D'utilisation page 23

PROBLEM
OZONATOR
FAILURE
FILTER PUMP
DOES NOT WORK
SPA TUB IN AN
ABNORMAL
SHAPE
SPA LEAKING
SPA LOOSES AIR
PRESSURE
WATER NOT
CLEAN
CONTACT YOUR LOCAL MSPA DEALER OR SERVICE CENTER FOR ANY PRODUCT RELATED QUESTIONS OR PROBLEMS.
CAUSE
Digital cable connection failure
Water level is not at the minimum
water line
One-way valve blocked
Filter pump does not work
Filter stuck by dirt or other objects
Filter system failure
Extra air pressure by strong
sunshine
Spa inlet/outlet connection not
securely tight
Drainage valve is not closed
completely
Water leaks from the spa pool body
Air valve got loosen
Hole or split on the spa tub
Water has been used too long
Insufficient filtering
Dirty filter cartridge
Improper water maintenance
Connect the digital cable once again,
ensure the pins inside are well connected
Add more water to the minimum line
Contact the MSpa Service Center
Refer to "FILTER PUMP DOES NOT WORK"
section
Clean or replace the filter cartridge
Contact the MSpa Service Center
Check the air pressure and release some
air if necessary. During hot weather, it is
recommended to check if it is necessary to
release some air to avoid any possible
damage to the spa pool.
Tighten the inlet and outlet connection
Contact the MSpa Service Center
Repair the leaking hole/spilt with the repair
kit material
Fill up the tub with air, make sure the air
valves are secure, replace if necessary
Put soap water in a squirt bottle and spray
on seams. If there is a leak it will bubble.
After you find the leak, clean and dry the
leaking area, then use the repair patch
comes with your spa. Check the repair
section on P20
Change the water
Increase filtration frequency
Clean or replace the filter cartridge in time
Refer to the chemical manufacture's
instruction
23
SOLUTION