Safety Instructions; Accessories; Scope Of Supply - Weller WSD 81 Manuel D'utilisation

b Lock:
Locking the setpoint temperature. Settings cannot be changed after
the soldering station has been locked.
b °C/°F:
Switching the temperature display from °C to °F, and vice versa.
b Window:
Limitation of the temperature range to max. ±99 °C based on a locked
temperature resulting from the "LOCK" function. The locked
temperature represents the median point of the adjustable temperature
range.
For units with a floating contact (optocoupler output) the "WINDOW"
function is used to adjust a temperature window. If the actual
temperature is within the temperature window the floating contact will
be enabled (optocoupler output).
b Cal:
Re-adjustment of the soldering station (WCB 2 only).
b PC interface: RS232 (WCB 2 only).
b Temp. gauge:
Integrated temperature gauge for thermal element Type K
(WCB 2 only).

5. Safety instructions

The manufacturer assumes no liability for uses other than those described in the
operating instructions, or for unauthorized alterations.
These operating instructions and warnings should be read carefully and kept in an
easily visible location in the vicinity of the soldering iron. Non-observance of these
warnings can result in accidents, injury or risks to health.
The WELLER soldering stations WSD 81 / WSL are in compliance with the EC
Declaration of Conformity in accordance with the basic safety requirements specified
by Directives 89/336/EEC and 73/23/EEC.
PK Elektronik Vertriebs GmbH, E-Mail: info@pkelektronik.com, Internet: www.pkelektronik.com

6. Accessories

5 29 161 99 Soldering iron set WSP 80
5 33 131 99 Soldering iron set MPR 80
5 33 112 99 Soldering iron set LR 21, antistatic
5 33 113 99 Soldering iron set LR 82
5 33 155 99 Soldering iron set WMP
5 33 133 99 Soldering iron set WTA 50
5 27 028 99 Preheating plate WHP 80
5 25 030 99 Thermal insulating unit WST 20
5 31 181 99 External input unit WCB 1
5 31 180 99 External input unit WCB 2
WPHT Stop and go iron stand (WMP)
WPH80T Stop and go iron stand (WSP 80)

7. Scope of supply

WSD 81 WSL
Control unit Control unit
Soldering iron WSP 80 Soldering iron WMP
Power cable Power cable
Operating instructions Operating instructions
Soldering iron rest Soldering iron rest
Jack (not USA ) Jack (not USA )
Illustration: Circuit diagram, see Page 62
Illustration: Exploded view, see Page 63/64
Subject to technical change without notice!
PUD 80
Control unit
Power cable
Operating instructions
Jack (not USA )
25