Shelving Confi Gurations - Viking Range 5 Serie Manuel D'installation, Utilisation Et Entretien

Shelving Confi gurations
Your appliance is equipped with full extension ball bearing
shelf glides to provide maximum access and visibility for
the product stored on the shelving arrangements listed
below.
VWUI5150 Single Zone Wine Cellar:
15" (38.1 cm) Wide models:
(6) 4 bottle wire racks
VWUI5240 Dual Zone Wine Cellar:
24" (61 cm) Wide models:
Upper Zone: (3) 8 bottle wire racks
Lower Zone: (1) 8 bottle wire rack
(2) 4 bottle half-depth wire racks
SHELVING CONFIGURATIONS
Figure 11
Figure 12
CAUTION
!
Never try to remove a loaded shelf, remove everything from
the shelf before removing. Use both hands when removing
the shelf.
To remove a shelf:
Extend the shelf out of the cabinet until it stops.
Unload the shelf (see Figure 13).
Depress the locking tabs on both sides of the shelf and pull
the shelf straight out (see Figure 13a). When the shelf is
removed, push the extended cabinet mounted shelf exten-
sions back into the cabinet.
To re-install a shelf:
Pull out the cabinet mounted shelf extensions to assist the
engagement with the wire rack shelf.
Insert the wire rack side track into the cabinet mounted
shelf extensions on both sides.
Push the wire rack completely into the cabinet to engage
the locking tabs.
Pull the shelf out, (unloaded), to verify the wire rack is
locked into the side rails. If the wire rack falls out, the lock-
ing tabs are not engaged; repeat the installation.
Load the shelf as required.
Figure 13
Locking tab
12
Remove the wine from the
shelf to be removed
Figure 13a