Blomberg BOTR30200CSS Manuel D'installation page 30

Four à micro-ondes à convection à hotte intégrée
Masquer les pouces Voir aussi pour BOTR30200CSS:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation
5
C3. Check blower plate
• Place the microwave in its upright position, with
the top of the unit facing up.
• Check to see that the blower plate is correctly
installed on the unit.
C4. Mount the microwave oven
C
For easier installation and person-
al safety, we recommend that two
people install this microwave oven.
A
Do not grip or use handle during in-
stallation.
C
If your cabinet is metal, use the ny-
lon grommet around the power cord
hole to prevent cutting of the cord.
C
We recommend using filler blocks if
the cabinet front hangs below the
cabinet bottom shelf.
A
If filler blocks are not used, case
damage may occur from overtight-
ening screws.
30 / 63 EN
Blower Plate
Over The Range Convection Microwave Oven / Installation Manual
1. Lift microwave, tilt it forward, and hook slots
at back bottom edge onto four lower tabs of
mounting plate.
When mounting the microwave
C
oven, thread power cord through
hole in bottom of top cabinet. Keep
it tight throughout Steps 1–3. Do not
pinch cord or lift oven by pulling cord.
2
2. Rotate front of oven up against cabinet bottom.
3. Insert a self-aligning screw through top center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after
the threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especially
when mounting flush to bottom of cabinet.
4. Attach the microwave oven to the top cabinet.
Cabinet Front
Cabinet Bottom Shelf
Microwave Oven Top
1
Filler Block
Equivalent
to Depth
of Cabinet
Recess
Self-Aligning Screw

Publicité

Chapitres

Table des Matières
loading

Table des Matières