Installation Types (Choose A, B Or C); Outside Top Exhaust (Vertical Duct) - Blomberg BOTR30200CSS Manuel D'installation

Installation
5
5.2 Installation types (choose
A, B or C)
this microwave oven is designed for adaptation to
the following three types of ventilation:
• Outside Top Exhaust (Vertical Duct Type A)
• Outside Back Exhaust (Horizontal Duct Type B)
• Recirculating (Non-Vented Ductless Type C)
Over The Range Convection Microwave Oven / Installation Manual
5.2.1 Outside top exhaust
(vertical duct type A)
Adaptor in Place for
Outside Top Exhaust
installation overview
A1. Attach Mounting Plate to Wall
A2. Prepare Top Cabinet
A3. Adapting Microwave Blower for
A4. Check Damper Operation
A5. Mount Microwave Oven
A6. Adjust Exhaust Adaptor
A7. Connect Ductwork
Adaptor Must Be
Moved to the Back for
Outside Back Exhaust
This microwave is shipped assem-
C
bled for Recirculating. Select the
type of ventilation required for your
installation and proceed to that sec-
tion.
Make sure the screws for the blower
A
motor and blower plate are securely
tightened when they are reinstalled.
This will help to prevent excessive
vibration.
A
Make sure the motor wiring has
been properly routed and secured,
and that the wires are not pinched.
3/8" TO EDGE
along the dotted line.
Trim the rear wall template
12"
NOTE: IT IS VERY IMPORTANT TO
THE DIRECTIONS
READ AND FOLLOW INSTRUCTIONS
IN THE INSTALLATION WITH THIS
BEFORE PROCEEDING
REAR WALL TEMPLATE. 4"
This Rear Wall Template serves to position the bottom the horizontal exhaust
mounting plate and to locate
outlet. that the template is positioned
1. Use a level to check
2. Locate and mark at least accurately. one stud on the left or
right side of the centerline.
It is important to use at a stud to support the weight least one wood
screw mounted firmly in two additional, evenly spaced
of the microwave. Mark toggle bolts.
3. Drill holes in the marked locations for the supplied locations. Where there is
a stud, drill a 3/16" hole a stud, drill 5/8" holes for for wood screws. For holes
that do not line up with
toggle bolts. MOUNTING PLATE
DO NOT INSTALL THE
4. Remove the template AT THIS TIME. from the rear wall.
5. Review the Installation Instruction book for your
installation situation.
Darle vuelta a la hoja para consultar la
versión en Español.
to align with holes in the
Locate and mark holes
mounting plate.
IMPORTANT: LOCATE AT LEAST ONE STUD ON EITHER SIDE OF
THE CENTERLINE. EVENLY
MARK THE LOCATION FOR 2 ADDITIONAL,
SPACED TOGGLE BOLTS IN THE MOUNTING PLATE
to align with holes in the
AREA. Locate and mark holes
mounting plate.
IMPORTANT: LOCATE AT LEAST ONE STUD ON EITHER SIDE OF
THE CENTERLINE. EVENLY
MARK THE LOCATION FOR 2 ADDITIONAL,
along the dotted line. SPACED TOGGLE BOLTS IN THE MOUNTING PLATE
Trim the rear wall template
AREA.
17 / 63 EN