Aligning The Wall Plate - Blomberg BOTR30200CSS Manuel D'installation

Installation
5
NOTE: IT IS VERY IMPORTANT TO
READ AND FOLLOW THE DIRECTIONS
IN THE INSTALLATION INSTRUCTIONS
BEFORE PROCEEDING WITH THIS
REAR WALL TEMPLATE.
This Rear Wall Template serves to position the bottom
mounting plate and to locate the horizontal exhaust
outlet.
1. Use a level to check that the template is positioned
accurately.
2. Locate and mark at least one stud on the left or
right side of the centerline.
It is important to use at least one wood
screw mounted firmly in a stud to support the weight
of the microwave. Mark two additional, evenly spaced
locations for the supplied toggle bolts.
3. Drill holes in the marked locations. Where there is
a stud, drill a 3/16" hole for wood screws. For holes
that do not line up with a stud, drill 5/8" holes for
toggle bolts.
DO NOT INSTALL THE MOUNTING PLATE
AT THIS TIME.
4. Remove the template from the rear wall.
5. Review the Installation Instruction book for your
installation situation.
Darle vuelta a la hoja para consultar la
versión en Español.
Locate and mark holes to align with holes in the
mounting plate.
IMPORTANT:
LOCATE AT LEAST ONE STUD ON EITHER SIDE OF
THE CENTERLINE.
MARK THE LOCATION FOR 2 ADDITIONAL, EVENLY
SPACED TOGGLE BOLTS IN THE MOUNTING PLATE
AREA.
Hole B
Horizontal Line
Area E
A
Wear gloves to avoid cutting fingers
on sharp edges.

5.1.4 Aligning the wall plate

1. Draw a Vertical line on the wall at the center of
the 30" wide space.
2. Draw a Horizontal line on the wall at the bottom
of "Rear Wall Template".
3. Drill 5/8" holes for toggle bolts on 2 locations
(Hole A, Hole B) but if the location of hole is
same as that of stud, drill a 3/16" hole for wood
screw. In other words, toggle bolt can not be
used to the location of stud.
C
DO NOT MOUNT THE PLATE AT THIS
TIME.
16 / 63 EN
3/8" TO EDGE
12"
Trim the rear wall template along the dotted line.
4"
Locate and mark holes to align with holes in the
mounting plate.
IMPORTANT:
LOCATE AT LEAST ONE STUD ON EITHER SIDE OF
THE CENTERLINE.
MARK THE LOCATION FOR 2 ADDITIONAL, EVENLY
Centerline SPACED TOGGLE BOLTS IN THE MOUNTING PLATE
AREA.
Draw a Vertical Line
notches
on Wall from Center
of Top Cabinet
Hole A
C L
Draw a Horizontal line on wall from
bottom of "Rear Wall Template".
Over The Range Convection Microwave Oven / Installation Manual
Horizontal Line
Holes A and B are inside area E. If
both of A and B are not in a stud,
find a stud somewhere in area E and
C
draw a forth circle to line up with the
stud. It is important to use at least
one wood screw mounted firmly in
a stud to support the weight of the
microwave. Set the mounting plate
aside.