Hilti TE 70-AVR Mode D'emploi page 13

Perforateur-burineur
Masquer les pouces Voir aussi pour TE 70-AVR:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14
Trouble or fault
No hammering action.
Combihammer does not
achieve full power.
Drill bit does not rotate.
Drill bit is not released.
The service indicator blinks
red.
The service indicator lights
red.
9 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Disposal of electric tools or appliances together with household waste is not permissible.
10 RoHS (Restriction of Hazardous Substances)
Click on the links to go to the table of hazardous substances: qr.hilti.com/r1021413 (TE70-AVR),
qr.hilti.com/r1021424 (TE70-ATC/AVR) and qr.hilti.com/r1021505 (TE80-ATC/AVR).
There is a link to the RoHS table, in the form of a QR code, at the end of this document.
11 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
Printed: 10.11.2017 | Doc-Nr: PUB / 5150798 / 000 / 05
Possible cause
The power tool is too cold.
The extension cord is too long or
the conductor cross-section is
inadequate.
The control switch is not fully
pressed.
The voltage provided by the elec-
tric supply is too low.
TE 70-ATC/AVR
TE 80-ATC/AVR
The half-power button is engaged.
The function selector switch is not
engaged or is in the "Chiseling"
position
or the "Chisel position-
ing" position
.
The chuck is not pulled back fully.
The side handle is not fitted cor-
rectly.
A fault has occurred in the tool.
The carbon brushes are worn.
Action to be taken
▶ Bring the tip of the accessory
tool into contact with the
working surface, switch the
power tool on and allow it to
run. If necessary, repeat the
procedure until the hammering
mechanism begins to operate.
▶ Use an extension cord of an
approved length and / or of
adequate conductor cross-
section.
▶ Press the control switch as far
as it will go.
▶ Connect the power tool to a
different power source.
▶ Press the "half-power" button.
▶ With the motor at a standstill,
set the function selector switch
to the "Hammer drilling"
position.
▶ Pull the chuck back as far
as it will go and remove the
accessory tool.
▶ Disengage the side handle and
refit it correctly so that the
clamping band and side handle
engage in the recess.
▶ Have the product repaired by
Hilti Service.
▶ Have checked, and if necessary
replaced, by a trained electrical
specialist.
English
9

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Te 70-atc/avrTe 80-atc/avr

Table des Matières