Dexter 20VID3-60BLA.1 Mentions Légales & Consignes De Sécurité page 214

FR
6.OPERATION
ES
PT
. To switch on the tool, press the on/off switch
. To switch off the tool, release the on/off switch
IT
EL
Set the Left/right switch to
PL
Set the Left/right switch to
. Change the direction of rotation only when the machine is not in operation !
RU
CAUTION! Set left/right switch to center switch Lock position during set up, when changing torque
setting or when tool is idle.
KZ
CAUTION! Operating the machine with a low speed for a long time will increase the risk that the
motor will be overheated. To prevent overheating, let the motor cool down regularly ( Stop using
UA
the machine for 15 minutes )
CAUTION: Please support and clamp the workpiece properly. Do not use hand to grip or
RO
clamp the workpiece, it may cause injury.
BR
You can change the speed by operating the speed selector button on the top of machine. The
EN
number 1 and 2 mean two different speeds.
The tool has an LED light to illuminate the work area and improve vision when working in areas with
insufficient light.
The LED light will switch on automatically while the trigger switch is depressed.
The torque setting will help you regulate the driving power when using a screwdriver bit. This will
help to prevent damage to the workpiece
Three function modes:
. . For screwing,set the function switching ring to the position indicated by the screw symbol.
. . For drilling, set the function switching ring to the position indicated by the drill bit symbol.
. . For impact mode,set the function switching ring to the position indicated by the hammer symbol.
Advice: Always start with the lowest torque setting and increase If necessary.
214
On/off switch
Left /right switch
shown on the left/right switch
Variable speed
LED worklight
Torque setting