Gas Appliance Safety; Equipment And Usage Safety Requirements; Appliance Handling Safety; Safety Codes And Standards - Gaggenau CG 280 210CA Instructions D'installation

9 IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS

Gas Appliance Safety

IMPORTANT : THE APPLIANCE HAS TO BE INSTALLED
BY A QUALIFIED INSTALLER.
INSTALLER: LEAVE THESE INSTRUCTIONS WITH THE
APPLIANCE AFTER INSTALLATION IS COMPLETE.
IMPORTANT: SAVE FOR THE LOCAL INSPECTOR'S
USE.
OWNER: PLEASE RETAIN THESE INSTRUCTIONS FOR
FUTURE REFERENCE.
9
WARNING
Do not repair, replace or remove any part of the appliance
unless specifically recommended in the manuals.
Improper installation, service or maintenance can cause
injury or property damage. Refer to this manual for
guidance. All other servicing should be done by a
qualified technician.
▯
Install a gas shutoff valve near the appliance. It must
be easily accessible in an emergency.
▯
Leak testing must be conducted by the installer
according to the instructions in this manual.
▯
The appliance and its individual shutoff valve must be
disconnected from the gas supply piping system
during any pressure testing at pressures in excess of
½ psi (3.5 kPa).
▯
The appliance must be isolated from the gas supply
piping system by closing its individual manual shutoff
valve during any pressure testing of the gas supply
piping system at test pressures equal to or less than
½ psi (3.5 kPa)
▯
The minimum supply pressure must be 1" water
column above the manifold pressure printed on the
data plate.
▯
The maximum supply pressure must not exceed 14.0
inches water column (34.9 Millibars).
▯
For Massachusetts installations:
‒ Installation must be performed by a qualified or
licensed contractor, plumber or gas fitter
qualified or licensed by the state, province or
region where this appliance is being installed.
‒ Shut-off valve must be a "T" handle gas cock.
‒ Flexible gas connector must be new and not
longer than 36 inches.
▯
Installer - show the owner where the gas shut-off
valve is located.
6
Equipment and Usage Safety
Requirements
▯
The cooktop must be used in conjunction with a
suitable ventilation system.
▯
Remove all tape and packaging before using the
appliance. Destroy the packaging after unpacking
the appliance. Never allow children to play with
packaging material.
▯
Never modify or alter the construction of the
appliance. For example, do not remove panels, wire
covers or screws.
▯
To eliminate the risk of burns or fire by reaching over
heated surface units, cabinet storage space located
above the surface units should be avoided. If cabinet
storage is to be provided, the risk can be reduced by
installing a hood that projects horizontally a minimum
of 5 inches beyond the bottom of the cabinet.
▯
Verify that cabinets above the cooktop are a
maximum of 13" (330 mm) deep.

Appliance Handling Safety

▯
Unit is heavy and requires at least two people or
proper equipment to move.
▯
Hidden surfaces may have sharp edges. Use caution
when reaching behind or under appliance.

Safety Codes and Standards

This appliance complies with one or more of the following
Standards:
▯
ANSI Z21.1, Household Cooking Gas Appliances
It is the responsibility of the owner and the installer to
determine if additional requirements and/or standards
apply to specific installations.
Installation must conform with local codes or, in the
absence of local codes, with the National Fuel Gas Code,
ANSI Z223.1/NFPA 54.
The appliance must be electrically grounded in
accordance with local codes or, in the absence of local
codes, with the National Electrical Code ANSI/ NFPA 70,
latest edition. (In Canada, installation must be in
accordance with the CAN 1-B149.1 and .2 Installation
Codes for Gas Burning Appliances and/or local codes).