Gaggenau CG 280 210CA Instructions D'installation page 11

Placing Burner Caps
Each cap has a letter (A, D, or F) cast in the underside
of the cap that corresponds to a letter (A, D, or F) cast
in the burner base that is attached to the appliance.
▯
After electrical connection is complete, place
each burner cap on its correct burner base per its
corresponding letter designation.
"Burners Caps"
.
▯
Place each burner cap gently on top of its base
so that the prongs of the burner base fit snugly
into the groove of the burner cap.
Burner Base
Matching letter
designation
Burner Cap
See Figure 10:
Figure 10: Burners Caps
Checking Burner Cap Placement
▯
Check to make sure there is no gap between the
burner cap and burner base.
the correct and incorrect placements of the
burner cap.
▯
You may gently try to move the burner cap from
side to side to check if it is properly placed. If
properly placed, the cap will click from side to
side as the prongs hit the groove ridge.
Correct Burner Cap Placement
Incorrect Burner Cap Placement
See Figure 11
to see
Figure 11: Burner Cap Placement
11