Settings And Connections; Changing The Jumper Pin Setting - Panasonic LF-M621U Mode D'emploi

ENGLISH

Settings and connections

This is IDE equipment that conforms to ATAPI specifications.
Connection example:
•
Computer mother boards have two IDE interface connectors: a primary and a secondary.
•
You can connect a total of four units to the mother board: one master and one slave IDE unit to the
primary connector, and one master and one slave IDE unit to the secondary connector.
•
We recommend connecting this unit as a master to the secondary connector.
Unit 1 set as master
Before connecting this drive
•
Be sure to read the operating instructions and operating precautions for the computer into which the
drive will be installed.
•
Turn off the computer and unplug the power cord from the power socket.
(Never connect the drive while the power is on.)
•
Do not place the drive where it will be susceptible to vibration or impact or where the surface is
tilted.
•
Be sure to observe all operating environment restrictions as noted in "Specifications" on page 152,
153 and 154.

Changing the jumper pin setting

This drive is set as a master at the time of shipment.
There is a jumper pin switch on the rear panel of the drive.
Set the unit to either master or slave, using the above connection example as a guide.
Jumper pin
Caution:
•
Do not mount the jumper pin sideways or in any position other
than specified. This can cause the drive to malfunction.
30
Computer mother board
Primary
Unit 2 set as slave
Master setting
Slave setting
Secondary
Unit 3 set as master Unit 4 set as slave
Not allowed (example)