Best CP45I Serie Guide D'installation page 16

23. OPERATION (
CONT
• H S ™
EAT ENTRY
This power pack is equipped with a Heat Sentry™ thermostat. This thermostat is a device that will start or speed up the blower if it
senses excessive heat above the cooking surface.
1. If blower is OFF - it turns blower ON to HIGH speed.
2. If blower is ON at a lower speed setting – it turns the blower up to HIGH speed.
NOTE: When Heat Sentry™ is activated, the communication coming from the LinkLogic
function is inactivated.
The HEAT SENTRY can start the blower during a range top fire or other excessive heat situations even if the hood
is turned off. In this case, it is impossible to turn the blower OFF with blower switch. If you must stop the blower,
do it from the main electrical panel.
When the temperature level drops to normal, the blower will return to its original setting.
• L L ® N
INK OGIC ETWORK COMPATIBILITY
Your CP45I, CP47I or CP47E Series power pack can be linked to LinkLogic network, if installed in your house.
• L L ® L
INK OGIC INKING
1. I L L
NITIALIZE THE INK OGIC DEVICE TO BE LINKED
Make sure that the LinkLogic device to be linked is initialized (default state, see instructions of LinkLogic device).
2. A
CTIVATE THE LINK MODE OF THE POWER PACK
Simultaneously press the push buttons 3 and 4 for 2 seconds; all 4 speed level LEDs flash.
L W
INK FOR
R C
EMOTE ONTROL OR
A L
CTIVATE THE INK MODE OF THE
Push the Link button of the LinkLogic device for
a specific duration to activate its Link mode
(see instructions of LinkLogic device).
S A -L
TART THE UTO
Press and release push button 4 to start the
Auto-link process, all 4 speed level LEDs
flash in rotation.
NOTE: For some LinkLogic
not flash because the linking duration is too
short.
3. E L
XIT INK MODE OF THE POWER PACK
Press and hold the Exit Link Mode push button (push button 2 on control illustration) for 2 seconds to exit Link mode. Link mode
remains activated for 4 minutes if no other operation is done.
' )
D
I
NSTRUCTIONS
R C ,
ALL EMOTE ONTROL
R B M
EMOTE LOWER ODULES
®
L L
INK OGIC DEVICE
INK PROCESS OF THE POWER PACK
® devices, LEDs might
L
Go back to the appropriate first step if another
LinkLogic device needs to be linked. Otherwise, to
Exit Link mode of the power pack.
WARNING
!
Press push button 3 to start the Master link process,
Wait until the LEDs stop flashing from the power
®
L L
INK OF ANOTHER INK OGIC DEVICE
exit Link mode, go to:
16
® device is disabled and the "DELAY OFF"
L S
INK FOR MART
M -U A
OR AKE P IR
G 24 (
O TO STEP ON NEXT PAGE
L L
TO CONFIGURE INK OGIC BOARD JUMPERS
BASED ON BLOWER PERFORMANCE
S M
TART THE ASTER LINK PROCESS OF THE POWER PACK
all 4 speed level LEDs flash in rotation,
meaning that the power pack is waiting for a
SmartSense or Make-Up Air module to Link.
A L
CTIVATE THE INK MODE OF THE
Push the Link button of the LinkLogic device
for a specific duration to activate its Link mode.
pack interface to do the next step.
S ™
ENSE
M
ODULES
)
.
®
L L
INK OGIC DEVICE