Replacing The Line; Replacing Trimmer Line; Service And Maintenance; Trouble Shooting - Dolmar ET-70 C Instructions D'emploi

replacing trimmer line

6
2 3 7
B
Before replacing the trimmer line, always switch off the
motor and disconnect the power cable!
- Press the tab (B/1) and turn the housing cover (B/2) as far
as it will go (lug on cover (B/3) centredon the tabSperre).
- Take the housing cover (B/2) off the housing (B/4). Remove
the spool (B/5) from the housing and remove any remaining
line.
Servicing and maintenance
Service

Trouble shooting

Fault
Motor doesn't work
Poor peformance
Trimmer head does not rotate
Poor trimming results
Trimmer line cannot be
Adjusted during operation
8
5 8 4 1
Cause
No power supply
Cable defective, plug defective,
ON/OFF switch defective, motor defective
Carbon brushes worn
Grass or debris blocking the head
Flexible shaft in shaft tube defective
Tirmmer line too short
Tirmmer line too short
Tirmmer line used up
Tirmmer line improperly wound
Dirty
- Cut trimmer line (dia. 2 mm x 5 m, order no. 369 224 060)
to 3.6 m length.
- Pull the line through the hole on the winding ridge of the
spool until both ends are the same length. Wind the line
tightly in the direction of the arrow until only about 0 cm is
left on each end.
- Push one line end into the assembly cutout (B/6), wind the
other end another half-turn, and press it into the opposite
assembly cutout (B/7).
- Put the spool in the housing (position it so the line ends in
the assembly cutouts are lined up with the line guides). Press
the spool into the housing and lead the line ends through
the guides (B/8), and pull on each line end so it comes out
of the assembly cutout.
- Put the housing cover (B/2) on, with the lug on the cover
(B/3) again centred on the tab (B/1), press lightly and turn
clockwise until you hear it click in.
We recommend that a comprehensive maintenance and in-
spection be performed at regular intervals. Any maintenance
or adjustment work not described in this manual may be
performed only by a DOLMAr service location.
remedy
Connect to power source
Check fuse
Have repaired
Have repaired
Clean
Have repaired
Adjust
Adjust manually
Replace
Rewind
Clean
23