Cleaning The Tool - Dolmar HT-355 Manuel D'instruction

1
2
009293
CAUTION:
The blade cover (standard equipment) cannot be
•
installed on the tool with the chip receiver being
installed. Before carrying or storing, uninstall the
chip receiver and then install the blade cover to
avoid blade exposure.
NOTE:
Check the chip receiver for secure installment
•
before use.
Never try to uninstall the chip receiver by an
•
excessive force with its hooks locked in the blade
unit grooves. Using the excessive force may
damage it.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.

Cleaning the tool

Clean out the tool by wiping off dust with a dry or soap-
dipped rag.
CAUTION:
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
Blade maintenance
Smear the blade before and once per hour during
operation using machine oil or similars.
After operation, remove dust from both sides of the
blade with wired brush, wipe off it with a rag and then
apply enough low-viscosity oil, such as machine oil etc.
and spray-type lubricating oil.
CAUTION:
Do not wash the blades in water. Failure to do so
•
may cause rust or damage on the tool.
1. Press the levers
on both sides
2. Unlock the
hooks
9
Removing or installing shear blade
CAUTION:
Before removing or installing shear blade, always
•
be sure that the tool is switched off and unplugged.
When replacing the shear blade, always wear
•
gloves without removing blade cover so that hands
and face does not directly contact the blade.
Failure to do so may cause personal injury.
NOTE:
Do not wipe off grease from the gear and crank.
•
Failure to do so may cause damage to the tool.
For specific way of removing and installing shear
•
blades refer to the reverse of a package for
accessory shear blades.
Removing the shear blades
Reverse the tool and loosen four screws.
1
2
009295
NOTE:
Be careful not to get your hands dirty as grease is
•
applied in the shear blade driving area.
Remove the under cover.
1
009296
Remove the gear housing cover.
1
009297
Set the crank at the angle as shown in the figure with a
slotted bit screwdriver.
1. Screws
2. Blade cover
1. Under cover
2. Blade cover
2
1. Gear housing
cover