Robert Juliat 1011+ Dossier Technique page 53

robert
juliat
HOW TO ADJUST THE MAINS POWER INPUT.
1
6
2
3
6
1
- Make sure the unit is disconnected from the mains.
- Lay down the unit as shown in the diagram above.
- Unscrew 16 HC 5 x 16 screws 1 . A 4mm HC key required.
- Remove the handles on both sides of the unit.
- Slide the cover towards the front, just until you can remove it.
- Disconnect the earth wire connected to the cover 2 .
- Now you can acceed to the choke's terminal 3 .
- Do not remove the wires connected to the "0" position.
- Place the ring tongue terminal 4 on the voltage required.
- Make sure that all the nuts 5 are well tighten by using two 8 size spanners
for the M5 nuts.
- Reconnect the earth wire 2 to the cover.
- Replace the cover as explained for removing it, but in reverse order. Then
tighten the screws 1 , without forgeting the washers 6 (earth continuity).
- Display the correct voltage plate 7 , that has been connected.
33
robert juliat
TECHNICAL FILE
HMI 1200 FOLLOWSPOT
0 -
208V 60Hz -
230V 50Hz -
245V 50Hz -
4
5
1011
1011
1011
A DATER DU:
VALID SINCE:
208V 60Hz
245V 50Hz
220/240V 50Hz
7
ROUTE DE BEAUMONT F 60530 FRESNOY - EN - THELLE
TEL.: 33 (0)3.44.26.51.89 FAX : 33 (0)3.44.26.90.79
+
+
B
+
B
08.12.97