Robert Juliat 1011+ Dossier Technique page 45

robert
juliat
1.2. Untimely extinction of the lamp.
2. USING THE " ANALOG " MODE
2.1. The ballast and the CAD are on ;
the" lamp on" command is given,
but the lamp does not switch on.
2.2. Intimely extinction of the lamp.
29
robert juliat
TECHNICAL FILE
HMI 1200 FOLLOWSPOT
message displayed :
LAMP OFF
CHECK SECURITY
message unchanged.
message unchanged.
message displayed :
RJ LAMP LIGHTING
TRY FAILURE
message displayed :
LAMP FAILURE
CHECK SECURITY
message unchanged.
Message in
start-up display :
" RJ LAMP OFF "
Return to 1.1 and follow the
procedure.
Network transient failure : give the
off command, or switch off
the mains for 30 sec.
Check the analog command cable :
the command has not been
recieved.
( refer to Tech. File page 12 )
Return to 1.1 and follow the
procedure.
Return to 1.1 and follow the
procedure.
Network transient failure : give the
off command, or switch off
the mains for 30 sec.
Command signal failure :
check the cable
( refer to Tech. File page 12 )
1011
1011
1011
A DATER DU:
VALID SINCE:
Restart the
"LAMP ON"
procedure.
Restart the
"LAMP ON"
procedure.
Restart the
"LAMP ON"
procedure.
Restart the
"LAMP ON"
procedure.
ROUTE DE BEAUMONT F 60530 FRESNOY - EN - THELLE
TEL.: 33 (0)3.44.26.51.89 FAX : 33 (0)3.44.26.90.79
+
+
B
+
B
08.12.97