Starting And Stopping; Before Starting - Husqvarna DC 6000 Manuel D'utilisation

Before starting

WARNING! Please read the operator's
!
manual carefully and make sure you
understand the instructions before using
the machine.
Wear personal protective equipment. See
instructions under the heading "Personal
protective equipment".
Make sure no unauthorised persons are
in the working area, otherwise there is a
risk of serious personal injury.
• Check that the machine is assembled correctly and do
not show any signs of damage. See instructions in the
section "Assembling and adjustments".
• Perform daily maintenance. See instructions in the
section "Maintenance".
• Use the manual purge at start-up and before
operating.
NOTE!
When running the GM 3000, raise the skirt on the grinder
so that there is a gap of around 0.5 cm between the floor
and the machine skirt.
Changing the dust bags
Use Husqvarna recommended dust bags.
Use the manual purge 2 times before replacing the dust
bag. Once the dust bag has collected around 20 kg of
dust, to avoid lifting hazards caused by overfilling of dust
bags, the dust bag should be changed.
• Fit the dust bags in the holder.
10 – English
All manuals and user guides at all-guides.com

STARTING AND STOPPING

• Place the dust bag holder in the container.
• Pull the bag up from the bag holder around the
container. Use a tightening strap to secure the bag
around the container.
• Pull the dust bag around the bag holder.
• Close the bottom of the dust bag with cable ties.
• It is possible to fill a dust bag placed on a half pallet.
Remove the bottom plate under the cyclone container.
Place a half pallet underneath.
NOTICE! Check the dust bag regularly during operation
to avoid overfilling.
NOTICE! Be careful not to damage the cyclone cone
when cutting off a full dust bag.