Robert Juliat CYRANO 1015 Dossier Technique page 14

{
For
1015 BSM
model only.
Mains voltage.
- Check the conformity of the mains voltage input with the values indicated
on the identification plate of the PSU (mains voltage & lamp power).
Lighting unit / Power supply connection.
- Connect the lighting unit's power cable B by passing it
inside the yoke.
- Leave a little slack and then block the cable B into the lock e .
- Place the lamp into position - refer to section A - 11.
- Connect the cable o to the mains.
CAUTION - For your security !
- Never open the lamp house's bonnet and trapdoors
when the lighting unit is on.
- Do not change the safety switches.
- Never connect to a dimmable channel.
- Use only when the lamp is in place.
robert juliat
Route de Beaumont F 60530 Fresnoy-en-Thelle phone: +33 (0)3.44.26.51.89 - fax: +33 (0)3.44.26.90.79 - www.robertjuliat.fr
TECHNICAL FILE
2500W HMI FOLLOWSPOT
k
PUSH
DATA IN DATA OUT
EM XLR5 EF XLR5
l
m
CONNECTIONS.
Electronic
power supply unit.
B
o
• Use only the listed cables to connect to the mains -
Refer to the respective PSU technical fi le.
DESCRIPTION.
A 1015 M / (*)BSM - Motorised shutter version.
d - EM HARTING 16 x 16A power socket.
*f - Local control for motorised shutter,
dimming 0 to 10 (0 = shutter closed).
*g - Local control for motorised soft filter,
dimming 0 to 10 (0 = light beam not blurred).
*h - Soft filter flash.
*i - Shutter flash, full beam.
*j - Shutter flash, blackout.
*k - Fuse (10,3 x 38 - 2A).
*l - EM XLR 5 input DATA.
*m - EF XLR 5 output DATA
B Lamp cable.
Cable H07 RN-F 18G 1,5 mm
with 16 x 16A M/F HARTING connectors.
C Electronique power supply.
1015 /
1015 M / BSM
B, BS, M & BSM
Section A - 9
C
2
length 3m fitted