mspa MONO C-MO049 Mode D'emploi page 19

3. Smooth the surface to remove any air bubbles and allow it dry for 5-10 minutes
NOTE: Glue is not included.
1
Air leak from inside the valve
A. Disassemble the valve by using the wrench included in the repair kit and check the position.
B. Disassemble the sealing rubber on the valve and clean both.
C. Assemble the valve back.
D. Inflate the Spa tub until it's flat.
E. Tighten the valve further by wrench and inflate to recommended air pressure.
Storage and Prepare for the Next Time Use
1. Drain and clean the spa by following the
"Drainage" and "Spa Cleaning" sections
2. Reserve the set up instructions to deflate and
disassemble the spa tub, spa control unit and air
bladder
3. Make sure all the spa components and
accessories are thoroughly clean and dry before
storage. Air-dry the spa tub in the mild sun for
an hour before folding
4. Fold the spa tub loosely and avoid any sharp
corners to prevent damage or leakage to the spa
liner
2
pin hole pin hole
NOTE: Correctly use the wrench by pressing it with one hand on top.
SUN
19
3
®