Troubleshooting - mspa MONO C-MO049 Mode D'emploi

TROUBLESHOOTING

PROBLEM
NO DISPLAY ON
THE WIRED
CONTROLLER
NOT HEATING
PROPERLY
BUBBLE AIR
BLOWER DOES
NOT WORK
OZONATOR
FAILURE
FILTER PUMP
DOES NOT WORK
CAUSE
Power failure
PRCD is off
PRCD broken
Press the Reset button,
controller is not displayed
Temperature set too low
Dirty filter cartridge
Water level is not at the minimum
water line
Heater failure
Filter pump broken
Auto-off 10 minutes
Unidirectional threshold is not open
Control panel failure
Water level is below the minimum
water line
One-way valve blocked
Filter pump does not work
Filter stuck by dirt or other objects
Filter system failure
Check power supply
Reset PRCD by following PRCD Testing
section
Contact the MSpa Service Center
Contact the MSpa Service Center
Set a higher temperature
Clean or replace the filter cartridge
Add more water to the minimum line
Contact the MSpa Service Center
Contact the MSpa Service Center
Wait for 10 minutes
Contact the MSpa Service Center
Contact the MSpa Service Center
Add water above the minimum line
Contact the MSpa Service Center
Refer to "FILTER PUMP DOES NOT WORK"
section
Clean or replace the filter cartridge
Contact the MSpa Service Center
21
SOLUTION