Tool Inspection; Tool And Work Area Set-Up - RIDGID microEXPLORER Manuel De L'opérateur

Figure 8 – ON/OFF Button

Tool Inspection

WARNING
Daily before use, inspect your inspec-
tion camera and correct any problems
to reduce the risk of serious injury from
electric shock and other causes and
prevent tool damage.
1. Make sure the unit is OFF.
2. Remove the battery and inspect it for
signs of damage. Do not use the
microEXPLORER inspection camera if
the battery is damaged in any way.
3. Clean any oil, grease or dirt from the
equipment, especially the handles and
controls. This helps prevent the tool from
slipping from your grip.
4. Inspect the camera head lens for conden-
sation. To avoid damaging the unit, do not
use the camera if condensation forms
inside the lens. Let the water evaporate
before using again.
5. Inspect the full length of the cable for
cracks or damage. A damaged cable
could allow water to enter the unit and in-
crease the risk of electrical shock.
6. Check to make sure the connections be-
tween the handheld unit and imager
cable are tight. All connections must be
properly assembled for the cable to be
water resistant. Confirm unit is properly
assembled.
microEXPLORER
7. Check that the warning label is present,
firmly attached and readable. Do not op-
Port Cover
erate the microExplorer Digital inspec-
tion camera without the warning label.
ON\OFF
Button
Figure 9 – Warning Label
8. Check to make sure the expansion bay
door is fully closed.
9. With dry hands re-install the battery mak-
ing sure to properly close the battery
door.
10. Turn the power on (Figure 8) and make
sure the device cycles through the splash
screen and then displays the live screen.
Consult the troubleshooting section of
this manual if problems arise.
11. Turn camera OFF.
Tool and Work Area
Set-Up
Set up the microEXPLORER inspection
camera and work area according to
these procedures to reduce the risk of in-
jury from electrical shock, entanglement,
and other causes and prevent tool and
system damage.
1. Check work area for:
• Adequate lighting.
• Flammable liquids, vapors or dust that
may ignite. If present, do not work in
area until sources have been identified
and corrected. The microEXPLORER
inspection camera is not explosion proof
and can cause sparks.
Ridge Tool Company
™ Digital Inspection Camera
WARNING
7