Electromagnetic Compatibility (Emc); Tool Assembly; Changing/Installing Batteries; Installing Imager Head Cable Or Extension Cables - RIDGID micro CA-150 Mode D'emploi

comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reason-
able protection against harmful interference in
a residential installation.
This equipment generates, uses, and can ra-
diate radio frequency energy and, if not in-
stalled and used in accordance with the in-
structions, may cause harmful interference
to radio communications.
However, there is no guarantee that interfer-
ence will not occur in a particular installation.
If this equipment does cause harmful interfer-
ence to radio or television reception, which can
be determined by turning the equipment OFF
and ON, the user is encouraged to try to cor-
rect the interference by one or more of the fol-
lowing measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equip-
ment and receiver.
• Consult the dealer or an experienced radio/ -
TV technician for help.
Electromagnetic
Compatibility (EMC)
The term electromagnetic compatibility is
taken to mean the capability of the product to
function smoothly in an environment where
electromagnetic radiation and electrostatic
discharges are present and without causing
electromagnet interference to other equip-
ment.
The RIDGID micro CA-150 Inspect -
NOTI E
ion Camera conforms to all applicable EMC
standards. However, the possibility of it caus-
ing interference in other devices cannot be
precluded.

Tool Assembly

WARNING
To reduce the risk of serious injury dur-
ing use, follow these procedures for pro -
per assembly.

Changing/Installing Batteries

he micro CA-150 is supplied without batteries
T
installed. Remove the batteries prior to long
term storage to avoid battery leakage.
1. Squeeze the battery clips (See Figure 3)
and remove battery compartment from
the micro CA-150 Inspection Camera
micro CA-150 Inspection Camera
(See Figure 4). If needed, remove batter-
ies.
Figure 3 – Battery Compartment Cover
2. Install 4 new AA alkaline batteries (LR6),
observing the correct polarity as indi-
cated on the battery compartment. Only
replace in sets to help prevent battery
leakage.
3. Squeeze the clips and firmly insert into in-
spection camera. The holder will only go
in one way. Do not force. Confirm se-
curely attached.
Figure 4 – Battery Compartment
Installing the Imager Head
Cable or Extension Cables
To use the micro CA-150 Inspection Cam er a,
the imager head cable must be connected to
the handheld display unit. To connect the
cable to the handheld display unit, make sure
the key and slot (Figure 5) are properly a -
ligned. Once they are aligned, finger tighten
the knurled knob to hold the connection in
place.
Figure 5 – Cable Connections
Key
Slot
5