Twin Needle Sewing - Janome 2041 Manuel D'instructions

Twin Needle Sewing

q Pattern selector:
w Presser foot:
e Thread tension:
r Stitch length:
t Stitch width:
Cautions :
* Turn off the power switch before changing the needle.
* When sewing with the twin needle, test the stitches on a
scrap fabric before sewing on the actual fabrics.
* Do not set the stitch width at more than 3, or the needle
will hit the needle plate and the needle will break.
1. Draw both threads from the spools and pass them through
the points from z to n .
Make sure not to tangle the two strings of thread.
q Presser foot lifter
2. The threading paths from z to v are the same as single
needle.
3. Slip one of the threads into the needle bar thread guide on
the left, and the other on the right.
w Thread guide
4. Thread the needles from front to back.
* When changing the sewing direction, raise the needles
and turn the fabric.
(Except Model 2041S)
D, G (Models 2041SX, 2041NX)
D–L (Models 2049SX, 2049LX)
Zigzag foot
1–4
0.5–1 (Satin stitch patterns)
S.S. (Stretch stitch patterns)
3
I J K L
1
D G I J K L
A
C
D
E
L
F
K
G
J
H
I
1
3
4
2
5
6
62
2
4
2
1
1
3
0
4 0
1
2
3
5
2
3
4
5