ResMed AirFit P10 Mode D'emploi page 7


Refer to your CPAP or bilevel device manual for details on
settings and operational information.

Remove all packaging before using the mask.
Using your mask
When using your mask with ResMed CPAP or bilevel devices that
have mask setting options, refer to the Technical specifications
section in this user guide for mask selection options.
For a full list of compatible devices for this mask, see the
Mask/Device Compatibility List on www.resmed.com on the
Products page under Service & Support. If you do not have internet
access, please contact your ResMed representative.
Notes:

This mask is not compatible for use with ResMed
AutoSet CS

SmartStart may not operate effectively when using this mask
with some CPAP or bilevel devices that have this feature.

If you experience nasal dryness or irritation, using a humidifier is
recommended.
Fitting
1. Hold the pillows away from your nose ensuring that the pillow
size (eg, M) with the left (L) and right (R) indicators are correctly
facing towards you then guide the nasal pillows into your nostrils
(L into your left nostril, R into your right nostril). Pull the headgear
over your head by holding the bottom strap and stretching it
around the back of your head. The top strap should sit
comfortably on top of your head.
Tip! There are raised logos on top of the frame so you can feel
the correct way up when fitting in the dark.
2. Move the mask away from your face then place it back to get a
comfortable fit. Ensure the nasal pillows fit securely into your
nostrils with both pillows positioned upright.
™ ™
2 and VPAP Adapt SV devices.
English
3