ResMed AirFit P10 Mode D'emploi page 10

When all components including the vent are dry, reassemble
•
according to the reassembly instructions.
Weekly:
• Handwash the headgear in warm (approximately 86°F/30°C)
water using mild soap. It may be washed without being
disassembled. Rinse well and allow it to air dry out of direct
sunlight.
Reprocessing the mask between patients
Only Sleep Lab Mask (SLM) variants of the mask are intended for
multi-patient re-use. When using between patients, these masks
must be reprocessed according to cleaning and disinfection
instructions available on ResMed.com/downloads/masks.
Troubleshooting
Problem/possible cause
Pillows won't seal properly, mask is uncomfortable or causes red
marks
Pillows may have been fitted
incorrectly, adjusted incorrectly
or the headgear is fitted
incorrectly.
Inner wall position of one or both
pillows is incorrect.
Pillows are the wrong size.
Pillows may be dirty.
Headgear is too loose.
6
Solution
Check that the nasal pillows with the
left (L) and right (R) indicators are
inserted correctly (L into your left
nostril, R into your right nostril).
Carefully follow the fitting instructions.
Readjust the headgear to ensure it is
fitted comfortably.
Squeeze pillow sides to release inner
wall. The correct position is shown in
the reassembly instructions.
Talk to your clinician.
Clean pillows according to the
instructions.
Wash headgear to help it return to its
original form. Follow the washing
instructions.
Adjust the headgear split straps.