Videotec WASPT Manuel D'instructions page 10

6.1.6 Washer installation (ULISSE)
To attach the base to the support use the
provided screws (05), washers (06), screw
gaskets (07) and gasket (08).
Fastening the support (01), place the washer pipe
support (03) in the desired position.
Insert the cables inside the support so that they
protrude by about 50cm. Insert the cable in the cable
glands (02). Keeping the base (04) at about 20cm
(7.9in) from the support, lock the cable glands. Set
the base up on the stand arranging the cables inside.
Attach the base to the support using the screws
supplied (05).
Fig. 13
Cut the cables to size and either restore or make the
connections to the positioning unit.
Shorten the washer pipe (01) as needed. Unscrew the
nut (02) and slide it along the pipe. Insert the end of
the pipe into the ogive (03).
01
Fig. 14
8
02
07
01
06
05
03
02
Lock the nut to the coupling.
Fig. 15
Attach the pipe to the washer support using the
bracket (01), the screws (02) and the washers (03)
supplied.
Lock the coupling using the hoseclip (04) supplied
and connect the delivery hose (05).
03
04
02
03
08
Fig. 16
To calibrate the jet direct the nozzle towards the glass
of the housing.
Fig. 17
To start the washer refer to the pan & tilt manual.
01
04
05
MNVKWASPT_1426_EN