Anest Iwata iCon-M433N Mode D'emploi page 7

7.1 INSTALLATION SCHEME OF ICON-M433N & ICON-M333N
1. Place the equipment, on a horizontal surface floor.
2. Secure it firmly to the floor surface by means of the cart's fastening bracket (N). (2 holes - ø 9)
3. Firmly connect the suction hose set (E) to the paint inlet joint and the recirculation pipe (F) to the drain valve (D).
4. Connect the twin hose for paint & air, to the paint supply of delivery paint filter (C) and to the air supply of air regulator
joint (P).
5. Properly connect to ground, the free end of the ground wire (R).
6. Connect the spray gun to the other end of the air/paint twin hose.
7. Connect the air supply hose (Q) to the system.
7.2 INSTALLATION SCHEME OF ICON-A433N & ICON-A333N
1. Place the equipment, on a horizontal surface floor.
2. Secure it firmly to the floor surface by means of the cart's fastening bracket (N). (2 holes - ø 9)
3. Firmly connect the suction hose set (E) to the paint inlet joint and the recirculation pipe (F) to the drain valve (D).
4. Connect the paint hose to the paint supply of delivery paint filter (C).
5. Properly connect to ground, the free end of the ground wire (R).
6. Connect the spray gun to the other end of the paint hose.
7. Connect the air supply hose (Q) to the system.
CONFIGURATION OF EQUIPMENT
O
P
G
A
C
D
E
F
Airless and Multi Spray iCon Pumps
H
I
L
M
B
N
MAIN CONFIGURATION:
A Air motor
B Fluid pump
C Paint delivery filter _ TF-8N (100 mesh)
D Drain valve
50 Mesh ICON-M333N /-A333N: G1/2"
Suction
E
hose
15 Mesh ICON-M433N /-A433N: G1"
F Drain hose 1.7m - ø 6 x 8
G Safety ball valve
H Pressure regulator (for spray gun)
I Pressure regulator (for pump)
L Tip tray
M Cart set
N Fastening bracket
O Plate
P Supply air nipple to spray gun
Q Supply air to pump
R Ground wire 1.6m (Crimping terminal ø 6.5)
Q
R
OPTIONALS:
ICON-M333N /-M433N
Air supply hose to gun G1/4"B
Air supply hose to pump G1/4"B
Paint supply hose to gun G1/4"B
MSGS-200 Multi spray gun
PLUNGER PUMP
ICON-A333N /-A433N
---
ALG-7 TE Airless spray gun
7