Anest Iwata iCon-M433N Mode D'emploi page 21

13. TROUBLESHOOTING
Inconvenience Cause
a) The ball valve is not in the
proper position.
b) The air regulator is not open.
1. The air pressure does
not increase
c) Insufficient air pressure.
a) Clogged paint filter or paint
circuit.
2. The paint does not
flow out of the gun
b) Clogged nozzle.
c) Jammed safety stop
a) The air does not supply the
pump.
b) The pump has a technical
problem.
3. The pump does not
work
a) Some air got inside the paint
ducts.
b) Some air remains inside
4. The pump does not
the paint ducts.
stop.
Airless and Multi Spray iCon Pumps
Check
a) Make sure the ball valve
is in the proper position.
b) Check the proper functioning of
the regulator.
c) Check the proper functioning of
the manometer of pressure gauge.
a) Opening the drain valve, the
paint does not flow out.
a1) Opening the recirculation
valve the paint flows out regulaly,
but not when pulling the gun
trigger.
b) Remove the nozzle and pull
the trigger of the gun.
a) Check the air supply hose.
b) Separate the air motor from the
pumping group and test it using a
different air supply hose.
a) Make sure the dip tube is
properly connected
b) Make sure the paint is in
good condition and that the
suction hose set is fully dip-
ped in the product to be pum-
ped.
Solution
a) Adjust the ball valve in the proper
position.
b) If it is closed, open it.
If it is damaged, replace it.
c) If the compressor does not supply
enough air pressure, replace it with one of
greater capacity.
a) The paint circuit is obstructed from the
pump inlet to the fluid pipe fitting.
a1) The paint course, from fluid hose fitting
to the gun nozzle, is blocked. Check for the
obstructed point and remove the clogging;
this inconvenience is usually caused by the
obstruction of the gun filter.
*Refer to the instruction manual of spray
gun.
b) If the paint flows out it means that
the nozzle is clogged.
*Refer to the instruction manual of spray
gun.
c) Unlock the safety valve.
a) Replace it if spoilt or clogged.
b) If the motor is running properly, follow
the instructions provided in the solution
column, point 2 (a-b).
c) If the motor is not running properly,
disassemble the cylinder and inspect it.
*Refer to the instruction manual of air
motor.
In case of special anomalies, ship it
to our Customer Care Technical
Service.
a) Tighten suction hose fitting.
b) If the paint is in standard condition
increase its level at least until it fully
covers the suction hose set. Then, carry
out the start-up operations relative to the
release of air from the paint ducts.
21