Anest Iwata iCon-M433N Mode D'emploi page 5

VERSIONS
MULTI SPRAY PUMPS
ICON - M333N
4. PRODUCT IDENTIFICATION
PLATE DATA: The manufacturer's identification plate is applied on Multi Spray and Airless Units (see picture below). It must not be
removed at all, even if the equipment is resold. For any communication with the manufacturer always mention the serial number writ-
ten on the plate itself.
MULTI PUMP UNIT
D II 2G T6 X
A MODEL
MAX. AIR PRESSURE
B
(bar/psi/MPa)
MAX. FLUID PRESSURE
(bar/psi/MPa)
FLUID FLOW PER CYCLE
PRESSURE RATIO
5. BOX CONTENTS
Pump
Airless and Multi Spray iCon Pumps
ICON - M433N
SERIAL NO.
XXXX - XX
C
ICON-M333N
7bar - 100psi - 0.7MPa
224bar - 3200psi - 22.4MPa
60ml/cyc
32:1
When receiving the Pump, make sure that it has not been damaged during tran-
sport or storage and also check that all the following contents are inside the box.
Suction hose
AIRL AIRLESS UNITS
ICON - A333N
A _ MODEL
B _ MAX. WORKING PRESSURE
C _ SERIAL NUMBER
D _ CE MARKING -
• Environmental limits (ambient temperature 5°C ~ 40°C).
• Maximum superficial temperature: Temperature class T6.
Refer to: Maintenance instruction manual
50 mesh
Packings protection
15 mesh
ESS UNITS
ICON - A433N
2 x Hook spanner
Instruction manual
liquid
5