Installing The Handle - IKRA BT 2640 Manuel D'utilisation

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

• Before proceeding to adjust or repair the device,

make sure to stop the engine and detach the spark

plug cap from the spark plug.

• If the machine should be stored for a longer time,

drain fuel from the fuel tank and carburettor, clean

the parts, take the device to a safe place and make

sure that the engine has cooled down.

• Periodically perform inspections to ensure safe and

efficient operation of the device. Please contact

your dealer for a more comprehensive inspection of

your device.

• Keep the machine away from fire or sparks.

• It is assumed that a condition called Raynaud's

syndrome affecting the fingers of certain individu-

als may be brought about by exposure to vibration

and cold. Exposure to vibration and cold may cause

tingling and burning sensations followed by loss of

colour and numbness of the fingers. The following

precautions are strongly recommended as the mini-

mum exposure which might trigger the condition is

unknown.

• Keep your body warm, especially the head, neck,

feet, ankles, hands and wrists. Maintain good blood

circulation by performing vigorous arm exercises

during frequent work breaks and also by not smok-

ing.

• Limit the hours of operation. Try to fill each day with

jobs where operating the brush cutter or other hand-

held power equipment is not permanently required.

• If you experience discomfort, redness and swelling

of the fingers followed by whitening and loss of feel-

ing, consult your physician before further exposing

yourself to cold and vibration.

• Always wear ear protection, loud noise over a long-

er time may make cause hearing defects or even

deafness.

• Full face and head protection must be worn to pre-

vent injuries from falling objects or branches.

• Wear grip-safe heavy-duty work gloves to improve

your grip on the brush cutter handle. Gloves also re-

duce the transmission of vibrations to your hands.

• WARNING: The operating range of the cutter is still

dangerous while the device is coasting to a halt.

ASSEMBLY

INSTALLING THE PROTECTION COVER

GEGEAR BOX

Install the protection cover on the unit's main tube us-

ing the protection cover bracket and screws provided.

Put the protection cover in the correct position and

tighten the screws.

Attention : For cutting with a metal blade, the black

extension piece of the protection cover must be re-

moved. For cutting with the nylon line cutter, the black

extension of the protection cutter must always be at-

tached.