Troubleshooting - KitchenAid KESC307 Guide D'utilisation Et D'entretien

TROUBLESHOOTING

Try the solutions suggested here first in order to avoid the
cost of an unnecessary service call.
Nothing will operate
Is the power supply cord unplugged?
Plug into a grounded outlet.
Has a household fuse been blown or has the circuit
breaker been tripped?
Replace the fuse or reset the circuit.
Cooktop will not operate
Is the control knob set correctly?
Push in knob before turning to a setting.
On ceramic glass models, is the "Cooktop Lockout" set?
See "Cooktop Lockout" section.
On coil element models, is the element inserted properly?
See "Coil Elements and Burner Bowls" section.
Excessive heat around cookware on cooktop
Is the cookware the proper size?
Use cookware about the same size as the surface cooking
area, element or surface burner. Cookware should not extend
more than 1 in. (2.5 cm) outside the cooking area.
Hot surface indicator light stays on
Does the Hot Surface Indicator Light stay on after control
knob(s) have been turned off?
See "Cooktop Controls" section.
Cooktop cooking results not what expected
Is the proper cookware being used?
See "Cookware" section.
Is the control knob set to the proper heat level?
See "Cooktop Controls" section.
Is the appliance level?
Level the appliance. See the Installation Instructions.
On coil element models, is the element inserted properly?
See "Coil Elements and Burner Bowls" section.
Oven will not operate
Is the electronic oven control set correctly?
See "Electronic Oven Control" section.
Has a delay start been set?
See "Timed Cooking" section.
On some models, is the Control Lock set?
See "Control Lock" section.
On some models, is the Sabbath Mode set?
See "Sabbath Mode" section.
Oven temperature too high or too low
Does the oven temperature calibration need adjustment?
See "Oven Temperature Control" section.
On some models, does the cooling fan run during BAKE,
BROIL or CLEAN?
It is normal for the fan to automatically run when the oven is
in use. These help cool the electronic control.
Display shows messages
Is the display showing "PF"?
There has been a power failure. Clear the display. See
"Display(s)" section. On some models, reset the clock, if
needed. See "Clock" section.
Is the display showing a letter followed by a number?
Press CANCEL OFF to clear the display. See "Display(s)"
section. If it reappears, call for service. See "Assistance or
Service" section.
Is the display showing "F5" or "E3"?
The power cord is not properly grounded. See Installation
Instructions.
Is the display showing "CF"?
The oven is in the "Convect Full Meal" setting. See "Convect
Full Meal" section.
Self-Cleaning cycle will not operate
Is the oven door open?
Close the oven door all the way.
Has the function been entered?
See "Self-Cleaning Cycle" section.
On some models, has a delay start Self-Clean cycle been
set?
See "Self-Cleaning Cycle" section.
Has a delay start been set?
See "Timed Cooking" section.
Oven cooking results not what expected
Is the appliance level?
Level the appliance. See the Installation Instructions.
Is the proper temperature set?
Double-check the recipe in a reliable cookbook.
Is the proper oven temperature calibration set?
See "Oven Temperature Control" section.
Was the oven preheated?
See "Baking and Roasting" section.
Is the proper bakeware being used?
See "Bakeware" section.
Are the racks positioned properly?
See "Positioning Racks and Bakeware" section.
Is there proper air circulation around bakeware?
See "Positioning Racks and Bakeware" section.
Is the batter evenly distributed in the pan?
Check to make sure batter is level in the pan.
Is the proper length of time being used?
Adjust cooking time.
Has the oven door been opened while cooking?
Oven peeking releases oven heat and can result in longer
cooking times.
Are baked items too brown on the bottom?
Move rack to higher position in the oven.
Are pie crust edges browning early?
Use aluminum foil to cover the edge of the crust.
25