Installing The Actuator - Rauch AXIS QUANTRON-A Mode D'emploi

Masquer les pouces Voir aussi pour AXIS QUANTRON-A:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

AXIS conversion kit
05.

Installing the actuator

Requirements:
• The control unit is disconnected from the voltage supply.
• The actuators are disconnected from the control unit.
05.1. Insert both new panels according
to the marking and screw them
on loosely.
The panels are marked with "R"
and/or "L".
The photo shows the panel on
the left-hand side ("L") when
viewed in the direction of travel.
Legend
a)
M8 x 16 hexagonal screw
a) M8 hexagonal nut
05.2. Position the supplied gauge
between the left panel and the
metering slide using the flange
bolts.
Legend
a) Flange bolts
b) Gauge
a
a
Page 13 / 44
b
a
b
a

Publicité

Table des Matières
loading

Table des Matières