Commissioning And Operation - Mettler Toledo Optical O2 Simulator Manuel D'instruction

Optical O Simulator
2
3

Commissioning and Operation

Prerequisites:
• The transmitter is connected and powered.
• Depending on the sensor the M12 or the VP8
cable is connected to the transmitter. Refer to
the Operation Manual of the transmitter.
1. Connect the M12 or the VP8 cable from the
transmitter to the Optical O
2. Parameterize transmitter.
3. Select via the navigation keys "Sensor Type"
the sensor to be simulated.
4. Select via the navigation key "Condition
Mode" the parameter to be simulated.
3.1 Simulation of Sensor Data
The following values are fixed in the simulator. If
the system works properly these values are
shown in the transmitter.
ISM (sensor wear data)
DLI
ACT
Operating hours
Autoclaving cycles
SIP Counter
CIP Counter
Max. Temperature
© 02 / 1 8 Mettler-Toledo GmbH
Printed in Switzerland
Simulator.
2
300d
50d
2400 hrs
1
2
3
130 °C
Optical O
en
23
Simulator
2
30 422 249