Tivoli Audio MUSIC SYSTEM BT Manuel Utilisateur page 9

Guide To Features (Rear Panel)
1. FM ANTENNA SWITCH: Switch between internal and external FM antennas. If an external
antenna is used, the switch should be in the External position. This switch has no affect on
AM reception.
2. EXTERNAL FM ANTENNA INPUT: In most cases FM reception will be improved by sliding
the included external FM antenna over this "F" connector and setting the antenna switch to
External. To avoid damage, when removing the FM antenna, never pull it by the white cord.
Always grasp the antenna's black connector firmly and pull it straight out. For more, see the
section marked "Reception".
3. EXTERNAL AM ANTENNA INPUT: Connect the supplied external AM antenna's 3.5 mm
stereo male mini connector. Assemble the integrated base, (Figure 13) and adjust for best
reception for each station. There will be no AM reception unless the AM antenna is connected.
Fig 13
For more, see the section marked "Reception".
4. AUX IN: To hear audio from another device such as a TV or MP3 player, connect said device's
audio output to this stereo input and set the Source button to AUX. Switching to the Auxiliary
position does not turn on the connected device. This stereo input accepts a 3.5 mm stereo
male mini connector. Note you may need to adjust the volume level differently for an auxiliary
device than the level used for radio or CD listening.
5. MIX IN: Connect your computer's (or other device's) audio output to this input to hear its audio
mixed in with the tuner, CD, or auxiliary device if one is connected. The volume level of this input
must be adjusted at the source. This input accepts a 3.5 mm male stereo mini connector.
6. REC OUT: You can record from the Music System BT by connecting a cassette deck's audio
input (or other recording device) to this fixed level stereo output. The primary speakers will not
9 7 4 5 6
This device complies with Part 15 of the FCC Rules. Its operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
CAN ICES-3 (B)/NMB-3(B) FCC ID:XXX-XXXXXX IC:XXX-XXXXXXX
220-240VAC~ 50Hz
3 1 2 8
9 – ENGLISH