Tivoli Audio MUSIC SYSTEM BT Manuel Utilisateur page 6

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 60
Guide To Features (Front Panel)
11
5
4
16
1. POWER: Push to power the Music System BT On or Off (Standby).
2. ALARM 1/ALARM 2: Briefly press and hold Alarm 1 or 2. A beep will confirm you are in the
alarm set-up mode and the corresponding green LED will illuminate. Rotate and press the
Volume knob in to adjust and set the hour (which also determines AM and PM (Figure 1) and
minutes (Figure 2) and press in to set and move to the next setting. Note, adjusting the hour
does not affect the minutes and vise-versa. Set the alarm source (Figure 3 and 4) and alarm
volume (Figure 5) in the same manner. Setting the alarm source to "Bluetooth/AUX" will cause
the alarm to wake to a tone. You will not be able to set the alarm source to CD if a CD isn't
loaded inside. Bluetooth cannot be selected as an alarm source. When the alarm LED is off,
press the Alarm button once to set the alarm. The display will show the time the alarm is set
to wake. When the alarm LED is on, press the Alarm button briefly to turn it off. If the alarm is
set and power is lost, the alarm will still sound (the tone will sound in place of radio or CD) at
the designated time provided fresh batteries are correctly installed in the rear battery compart-
ment. When the alarm activates (Alarm LED flashes) you may either turn the unit off and keep
the alarm set for the next day, press the Snooze button to temporarily mute the alarm for 7
minutes, or briefly press the Alarm button to cancel activation,turning the unit off, and keeping
the alarm set to wake the next day.
Note: The non-US model uses a 24 hour clock format.
Fig 1, 2, 3, 4, 5
3. PRESETS 1–6: Press and hold to memorize the tuned station to that particular preset. A beep
will sound confirming the station has been successfully stored. Press briefly to recall the sta-
tion associated with that preset. There are 6 FM presets and 6 AM presets. If a Preset button
is pressed but no station has been set, the display will show "Preset Empty" for 2 seconds.
These buttons will also act as limited direct track access during CD playback. The same sta-
tion cannot be saved to more than 1 preset.
17
18
15
14
3
12
8
13
7
6
9
10
2
1
6 – ENGLISH

Publicité

Table des Matières
loading

Table des Matières