Fein MBS16X Mode D'emploi page 23

OBJ_BUCH-0000000161-003.book Page 23 Wednesday, April 25, 2018 9:07 AM
Use the magnetic drill stand/industrial drill stand suitable
for the performance characteristics of your drive motor.
Pay attention that the set-up surface for the magnetic foot
of the magnetic drill stand is flat, clean and rust-free.
Remove varnish and putty/filler layers.
Use the magnetic drill stand only with the magnetic foot
switched on.
When working with the magnetic drill stand on non-
magnetic materials, suitable FEIN fastening devices, such
as suction plate, vacuum plates or pipe drilling devices,
which are available as accessories, must be used.
Even when working on steel materials where the material
thickness is below 12 mm, the work piece must be made
thicker with an additional steel plate in order to ensure
the magnetic holding power of the magnetic drill stand.
Connect the drive motor only to the socket outlet on the
backside of the magnetic drill stand.
The magnetic foot of the magnetic drill stand is moni-
tored by means of a power sensor. If the magnetic foot is
defective, the drive motor will not operate.
Remove the application tool from the drill hole only
while the motor is running.
Should the application tool become stuck in the material,
stop the drive motor and remove the application tool by
carefully turning it anticlockwise.
Remove the chips and the drilled core after each drilling
process.
Do not touch the chips with your bare hand.
Always use a chip hook.
When changing the application tool, pay attention not to
damage its cutting edges.
When core drilling layered material, remove the core and
the chippings after drilling each layer.
With a tool inserted, the drive motor may not
move downward by itself.
When moving the magnetic drill stand with the
drive motor mounted, the unit can tip over when
the magnet is switched off. Therefore, secure the mag-
netic drill stand with a lashing strap.
Repair and customer service.
When working metal under extreme operat-
ing conditions, it is possible for conductive
dust to settle in the interior of the power tool.
The total insulation of the power tool can be impaired.
Blow out the interior of the power tool via the ventila-
tion slots frequently with dry and oil-free compressed air,
and connect a residual current device (RCD) on the line
side.
When the magnetic drill stand's power supply cable is
damaged, it must be replaced using a specially prepared
power supply cable, available from your FEIN customer
service agent.
The current spare parts list of this product can be found
on the Internet under www.fein.com.
If required, you can change the following parts yourself:
Application tools, chipping protector, capstan handle
with handle levers, holder of the drive motor
Warranty and liability.
The warranty for the product is valid in accordance with
the legal regulations in the country where it is marketed.
In addition, FEIN also provides a guarantee in accordance
with the FEIN manufacturer's warranty declaration.
The delivery scope of your product may include only a
part of the accessories described or shown in this Instruc-
tion Manual.
Declaration of conformity.
FEIN declares itself solely responsible for this product
conforming with the relevant provisions given on the last
page of this Instruction Manual.
Technical documents at: C. & E. Fein GmbH, C-D1_IA,
D-73529 Schwäbisch Gmünd
Environmental protection, disposal.
Packaging, worn out magnetic drill stands/industrial drill
stands and accessories should be sorted for environ-
ment-friendly recycling.
en
23