Fein MBS16X Mode D'emploi page 21

OBJ_BUCH-0000000161-003.book Page 21 Wednesday, April 25, 2018 9:07 AM
en Original Instructions.
Symbols, abbreviations and terms used.
Symbol, character Explanation
Make sure to read the enclosed documents such as the Instruction Manual and the General
Safety Instructions.
Observe the instructions in the text or graphic opposite!
Observe the instructions in the text or graphic opposite!
Before commencing this work step, pull the mains plug out of the socket. Otherwise there will
be danger of injury if the power tool should start unintentionally.
Use eye protection during operation.
Use ear protection during operation.
Do not touch the rotating parts of the power tool.
General prohibition sign. This action is prohibited.
Starts the drill motor. Rotation direction: clockwise
Stops the motor
Confirms the conformity of the power tool with the directives of the European Community.
This sign indicates a possible dangerous situation that could cause severe or fatal injury.
WARNING
Worn out power tools and other electrotechnical and electrical products should be sorted
separately for environmental-friendly recycling.
Product with basic insulation plus additional insulation on touchable, conductive parts con-
nected to the protective conductor.
Character Unit of measure-
ment, international
P
W
1
I A
max
U
V
f
Hz
M...
mm
Ø mm
mm
mm
mm
mm
Fe HSS
kg
kg
l x b
mm
mm
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
min, m/s
Unit of measure-
ment, national
W
A
V
Hz
mm
mm
mm
mm
mm
mm
kg
kg
mm
mm
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
2 2
min, m/s
Explanation
Power input
Maximum power consumption of the drive motor
Rated voltage
Frequency
Size of metric thread
Diameter of a round part
Drilling capacity in steel - high speed steel (HSS)
(twist drill bit)
Reamer diameter
Counterboring diameter
Drilling capacity in steel - high speed steel (HSS)
(screw tap)
Weight according to EPTA-Procedure 01
Maximum weight of the drive motor
Dimensions of magnetic-foot plate
Collar diameter of the drive motor
Basic and derived units of measurement from the
international system of units SI.
en
21