CAPITAL SPORTS Challenger 10035102 Mode D'emploi page 86

EN
86
Error message E05:
(after switch-on)
Overload protection
Error message E06:
(after switch-on)
Open circuits of the
motor
Error message E08:
(after switch-on)
Error in the memorizer
24C02
Error message E10:
(after switch-on)
Instantaneous short
circuit of the motor
Error message E13:
Communication failure
from control board to
display
The treadmill is overloaded, please restart.
Maybe some part is jammed which makes the
motor too heavy, so the machine cannot work.
Please adjust the running belt or lubricate with
some oil.
Check the motor, whether there is any special
smell or overload current. Have the motor
replaced.
Have the control board checked and replaced if
necessary.
The motor wire must be reconnected.
Have the motor replaced.
The memorizer IC is not well connected, please
reconnect.
The memorizer IC is broken, have the IC replaced.
The torque of the control board is too high. The
torque potentiometer must be adjusted so that
the torque value is reduced.
The motor is short circuit, have the motor
replaced.
The moving parts are shucked, please adjust and
lubricate them with oil.
The connection wire from the control board to
the control panel must be checked. Have the wire
replaced if broken.
Have the electronic parts of the display checked.
If it is out of order, have it replaced.
Have the control board replaced.