Power Fist 7 HP 212CC OHV Manuel D'instructions page 14

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

8913188
b.
Reinsert the dipstick into the filler neck until it rests on the opening's
rim. Do not screw the oil fill plug back into the opening (Fig. 4).
c.
Remove the dipstick and check that the oil is between the Full and
Fill marks. Add or drain oil based on the measurement.
d.
Reinsert the dipstick and either press firmly to hold in place or screw
the oil fill cap hand tight.
HOW TO ADD OIL
IMPORTANT! Read the Engine Oil section before adding oil to ensure that it is
suitable for the engine.
1.
Remove the oil filler cap (M) and place to one side.
2.
Place a funnel into the oil fill neck. The funnel opening should be wide
enough to prevent the oil from collecting in the funnel's cone.
3.
Pour oil into the funnel. Allow the oil to settle for one minute and recheck
the level. Repeat until the desired level is reached.
4.
Insert the oil filler cap
and hand tighten.
5.
Wipe up any spilled oil.
Dispose of oil soaked rags
in a proper hazardous
waste container.
HOW TO DRAIN OIL
WARNING! Do not tip the engine while draining. This can cause fuel to leak into
the oil compartment, creating a potential fire hazard. If this is unavoidable,
drain the fuel from the engine before draining the oil.
1.
Remove the dipstick (M).
2.
Place an approved container below the oil
drain plug (L).
3.
Remove the oil drain plug and allow oil to
the drain into the approved container.
4.
Install oil drain plug and tighten with a
wrench.
IMPORTANT! Used oil must be disposed of
properly. Do not pour it on the ground, down a
drain or throw it in the trash. Take the oil to your local recycling centre or a
service station for reclamation.
14
7 HP 212cc OHV Gas Engine with Electric Start
For technical questions call 1-800-665-8685
V1.0
Fig. 4
Fig. 5

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

8913188

Table des Matières