Ec Declaration Of Conformity; Safety Warnings - Makita DVC862L Manuel D'instructions

Noise
The typical A-weighted noise level determined accord-
ing to 60335-2-69:
Model DVC862L
Sound pressure level (L
Uncertainty (K) : 2.5 dB(A)
Model DVC863L
Sound pressure level (L
Uncertainty (K) : 2.5 dB(A)
The noise level under working may exceed 80 dB (A).
WARNING:
Wear ear protection.
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to 60335-2-69:
Vibration emission (a ) : 2.5 m/s
h,M
Uncertainty (K) : 1.5 m/s
NOTE: The declared vibration emission value has
been measured in accordance with the standard test
method and may be used for comparing one tool with
another.
NOTE: The declared vibration emission value
may also be used in a preliminary assessment of
exposure.
WARNING:
The vibration emission during actual
use of the power tool can differ from the declared
emission value depending on the ways in which the
tool is used.
WARNING:
Be sure to identify safety measures
to protect the operator that are based on an estima-
tion of exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it is
running idle in addition to the trigger time).

EC Declaration of Conformity

For European countries only
The EC declaration of conformity is included as Annex A
to this instruction manual.

SAFETY WARNINGS

Cordless vacuum cleaner safety
warnings
WARNING:
IMPORTANT! READ CAREFULLY
all safety warnings and all instructions BEFORE
USE . Failure to follow the warnings and instructions
may result in electric shock, fire and/or serious injury.
1. Before use, make sure that this cleaner must
be used by people who have been adequately
instructed on the use of this cleaner.
2. If foam/liquid comes out, switch off
immediately.
) : 70 dB(A) or less
pA
) : 70 dB(A) or less
pA
2
or less
2
3. Clean the water level limiting device regularly
and examine it for signs of damage.
Do not use the cleaner without the filter.
4.
Replace a damaged filter immediately.
5. AVOID UNINTENTIONAL STARTING. Be sure
switch is OFF when installing battery(ies).
6. Do not attempt to pick up flammable materials,
fire works, lighted cigarettes, hot ashes, hot
metal chips, sharp materials such as razors,
needles, broken glass or the like.
7. NEVER USE THE CLEANER IN THE VICINITY
OF GASOLINE, GAS, PAINT, ADHESIVES OR
OTHER HIGHLY EXPLOSIVE SUBSTANCES.
The switch emits sparks when turned ON and
OFF. And so does the motor commutator during
operation. A dangerous explosion may result.
8. Never vacuum up toxic, carcinogenic, com-
bustible or other hazardous materials such as
asbestos, arsenic, barium, beryllium, lead, pes-
ticides, or other health endangering materials.
9. Never use the cleaner outdoors in the rain.
10. Do not use close to heat sources (stoves, etc.).
11. Do not block cooling vents. These vents per-
mit cooling of the motor. Blockage should be
carefully avoided otherwise the motor will burn
out from lack of ventilation.
12. Keep proper footing and balance at all times.
13. Do not fold, tug or step on the hose.
14. Stop the cleaner immediately if you notice
poor performance or anything abnormal
during operation.
15. REMOVE THE BATTERY(IES). When not in use,
before servicing, and when changing accessories.
16. Clean and service the cleaner immediately after
each use to keep it in tiptop operating condition.
17. MAINTAIN THE CLEANER WITH CARE. Keep
the cleaner clean for better and safer per-
formance. Follow instructions for changing
accessories. Keep handles dry, clean, and free
from oil and grease.
18. CHECK DAMAGED PARTS. Before further use
of the cleaner, a guard or other part that is
damaged should be carefully checked to deter-
mine that it will operate properly and perform
its intended function. Check for alignment of
moving parts, binding of moving parts, break-
age of parts, mounting, and any other condi-
tions that may affect its operation. A guard or
other part that is damaged should be properly
repaired or replaced by an authorized service
center unless otherwise indicated elsewhere
in this instruction manual. Have defective
switches replaced by authorized service cen-
ter. Don't use the cleaner if switch does not
turn it on and off.
19. REPLACEMENT PARTS. When servicing, use
only identical replacement parts.
20. STORE IDLE CLEANER. When not in use, the
cleaner should be stored indoors.
21. Be kind to your cleaner. Rough handling can cause
breakage of even the most sturdily built cleaner.
22. Do not attempt to clean the exterior or interior
with benzine, thinner or cleaning chemicals.
Cracks and discoloration may be caused.
7 ENGLISH