Making A Bag Using The Bag Roll; Preserve Food With Vacuum - CASO DESIGN VC15 Mode D'emploi Original

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 43
16.3

Making a bag using the bag roll

Place the unit on a dry place. Make sure the working area in front of the unit is free of
obstacles and wide enough to accommodate the food bags.
1. Unroll the bag to the desired length and cut the bag to the appropriate length with
precise and clear cut.
2. Open the lid and put one end of the bag on top of the black rubber strip, then
close the cover (see Step 1).
3. Press the cover down heavily on both sides by the dotted areas using two hands
until two click sounds heard (see Step 2).
4. Press the "Schweißen"-Button and the red LED control light starts flashing.
5. When the LED light turns off, the bag is sealed.
6. Now you have a custom-sized bag.
► Make sure that the bag you want to use is at least 8cm/3.1in. longer than the food.
Add another 2 cm/0.8in. each time the bag is re-used.
16.4

Preserve food with vacuum:

6. After that press the two "Cover Lock"-buttons and the process is completed
(see Step3).
7. Check the appearance of the sealed bag; it should have a stripe across the
seal and no wrinkles otherwise the seal may not be complete.
8. If you need to interrupt the vacuum operation (e.g. the bag is incorrectly
positioned) first presses the "Stop" pushbutton and then the "Cover-Unlock"-
buttons.
► Do not put too much food inside the bag; leave enough empty length in the open end
of the bag so that the bag can be placed in the vacuuming plate more positively.
Please note
Please note
1. Put the food that you want to preserve
inside the bag.
2. Clean and straighten the open end of
the bag, make sure that there are no
wrinkles or ripples on the panels of the
open ends.
3. Place the bag as shown on the picture
in the device. Do not place the bag
over the intake (A), otherwise the
vacuum ca not be generated correctly.
4. Close the cover and then press
heavily on both sides of the cover in
the dotted areas until two click sounds
heard.
5. Press the "Vakuum & Schweißen"-
button then the bag will be
automatically vacuumed and sealed.
36

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

1371

Table des Matières