Others; Connecting Portable Audio Players To The Aux Jack; Switching The Aux Mode On And Off; Switching The Input System - Eclipse CD5100 Manuel D'utilisation

Others

Connecting portable audio
players to the AUX jack
Use a commonly available accessory cord with
the RCA connector or an optional AUX105 to
connect a portable audio player to the AUX
(auxiliary) jack of this system.
There are 2 connection terminals on this main
unit; one for RCA connector and the other for
optional LAN cable (AUX 105).
Turn on the portable audio player
1
and start its play function.
The AUX mode is activated.
For details, refer to "Switching Audio
Modes" on page 17.
ATTENTION
• While the AUX mode is activated, actions
such as turning off the audio player or
pulling out the connection cord may cause
noise spikes that can damage the system
speakers. Be sure to avoid this possibility
by turning off system power or switching
from AUX mode to another mode before
shutting off or disconnecting the portable
audio player.
• Audio output levels will differ for the various
devices that can be connected by this
method. Carefully adjust volume until the
output level of the connected player is
known.
• Before using a portable audio player in a
vehicle, read the player's operation manual
carefully and
operation in the vehicle before proceeding.
• When you connect an optional LAN cable
(AUX 105) to the main unit, another optional
equipment using
connected.
confirm problem-free
E-LAN cannot

Switching the AUX mode on and off

Press the [CUSTOM/MENU] button
1
for more than two seconds.
The Menu
activated.
Press the [SELECT] (Upper/Lower)
2
to select FUNC then press the
[ENTER] button.
The function mode is activated.
Press the [SELECT] (Upper/Lower)
3
button to select the AUX ON/OFF.
The AUX
activated.
Press the [SELECT] (Upper/Lower)
4
button to select the ON/OFF mode.
Press the button to switch mode as
follows:
Upper: ON
Lower: OFF
The selected settings will take effect.

Switching the input system

When using an optional AUX cord (AUX105), the
main unit can be switched between RCA input
and input from the optional AUX cord (AUX105).
Press the [MODE] button for more
1
than one second.
The system will switch between RCA
input and the optional AUX cord each
time the button is pressed.
be
RCA input (Input)
cord (Sub input)

Others

selection mode
ON/OFF mode
↔
Optional AUX
is
is
XVII
XVIII
75