Position Selector - Eclipse CD5100 Manuel D'utilisation

Press the [SELECT] (Upper/Lower)
2
button to adjust the Q curve
pattern.
Each time the button is pressed, the Q
curve pattern changes as follows.
When the Bass is selected:
WIDE ↔ MidWIDE ↔ NORMAL ↔
NARROW ↔ WIDE ↔
When the MIDDLE is selected:
NORMAL ↔ NARROW ↔
NORMAL ↔
When the TREBLE is selected:
NORMAL (FIX)
Press the [SELECT] (Right/Left)
3
button to adjust the frequency
level.
Each time the button is pressed, the
frequency level changes as follows.
When the BASS is selected:
60Hz ↔ 80Hz ↔ 100Hz ↔
120Hz ↔ 60Hz ↔
When the MIDDLE is selected:
700Hz (FIX)
When the TREBLE is selected:
7.5kHz ↔ 10kHz ↔ 12.5kHz ↔
15kHz ↔ 7.5kHz ↔
Press the [CUSTOM/MENU]
4
[RTN] button
adjustment mode.
ATTENTION
• Center frequencies and Q curves adjusted
here are reflected on BASS, MIDDLE and
TREBLE in the audio control mode. (Refer
to page 44 for details on audio control
operation.)
• When the center frequencies and Q curves
are adjusted, CUSTOM EQ will be updated.
or
to exit sound
How to operate the Sound Adjustment Mode

Position selector

Acoustics can be simply adjusted to listening
position.
Press the [SELECT] (Upper/Lower)
1
button to
Selector.
2
Press the [ENTER] button.
The Position Selector setting mode is
activated.
Press the [ENTER] and [SELECT]
3
(Upper/Lower/Right/Left) button to
select the desired position.
When each button is pressed, the
position changes as follows.
ENTER: OFF
UP: FRONT
DOWN: REAR
RIGHT: FRONT-RIGHT
LEFT: FRONT-LEFT
Press the
4
[RTN] button
adjustment mode.
select the Position
[CUSTOM/MENU]
to exit sound
X
or
49