Others; Connecting Portable Audio Players To The Aux Jack; Changing Auxiliary Input Sensitivity - Eclipse CD3000 Manuel D'utilisation

About optional equipment

Others

Connecting portable audio
players to the AUX jack
Use a commonly available accessory cord. With
a jack for AUX cord (AUX105), portable audio
players and other external inputs can be
connected to the system.
When the AUX cord is connected to the jack, CD
changer cannot be connected to the system.
Turn on the portable audio player
1
and start its play function.
Switch to the AUX mode by
2
pressing the [DISC] button for
more than one second.
Activation of the AUX mode will light
the "AUX" indicator and channel
audio player output to the system
speakers.
ATTENTION
• While the AUX mode is activated, actions
such as turning off the audio player or
pulling out the connection cord may cause
noise spikes that can damage the system
speakers. Be sure to avoid this possibility
by turning off system power or switching
from the AUX mode to another mode before
shutting off or disconnecting the portable
audio player.
• Audio output levels will differ for the various
devices that can be connected by this
method. Carefully adjust volume until the
output level of the connected player is
known.
• Before using a portable audio player in a
vehicle, read the player's operation manual
carefully and
operation in the vehicle before proceeding.
56
confirm problem-free

Changing auxiliary input sensitivity

The sensitivity of the auxiliary mode can be
changed.
1
Press the [FUNC] button.
The function mode is activated.
Turn the [SEL] button to select
2
AUX Sensitivity.
3
Press the [SEL] button.
The AUX sensitivity
activated.
Turn the [SEL] button to select the
4
sensitivity mode.
Turning the button allows you to
toggle through sensitivity modes as
follows:
Low ➔ Mid ➔ Hi ➔ Low
ATTENTION
Input sensitivity modes are roughly as follows:
Low
Mid
Hi
5
Press the [SEL] button.
The selected settings will take effect.
6
Press the [RTN] button.
At this time, other adjustments can
also be mode in function mode.
Press the [FUNC] or [RTN] button
7
to exit function mode.
mode is
1 Vrms
480 mVrms
240 mVrms