Others; Connecting Portable Audio Players To The Aux Jack; Switching The Aux Mode On And Off; Changing Auxiliary Input Sensitivity - Eclipse CD3100 Manuel D'utilisation

Others

Connecting portable audio
players to the AUX jack
Use a commonly available accessory cord with
an optional AUX105 to connect a portable audio
player to the AUX (auxiliary) jack of this system.
A connection terminal for optional LAN cable
(AUX105) is provided on this unit.
Turn on the portable audio player
1
and start its play function.
The AUX mode is activated.
For details, refer to "Switching Audio
Modes" on page 15.
ATTENTION
• While the AUX mode is activated, actions
such as turning off the audio player or
pulling out the connection cord may cause
noise spikes that can damage the system
speakers. Be sure to avoid this possibility
by turning off system power or switching
from AUX mode to another mode before
shutting off or disconnecting the portable
audio player.
• Audio output levels will differ for the various
devices that can be connected by this
method. Carefully adjust volume until the
output level of the connected player is
known.
• Before using a portable audio player in a
vehicle, read the player's operation manual
carefully and
operation in the vehicle before proceeding.
• When you connect an optional LAN cable
(AUX 105) to the main unit, another optional
equipment using
connected.

Switching the AUX mode on and off

Press the [EQ/MENU] button for
1
more than one second.
The Menu selection mode is activated.
confirm problem-free
E-LAN cannot
Press the [SELECT] (Upper/Lower)
2
to select FUNCTION then press the
[ENTER] button.
The function mode is activated.
Press the [SELECT] (Upper/Lower)
3
button to select the AUX.
The AUX mode is activated.
Press the [SELECT] (Upper/Lower)
4
button to select ON/OFF.
Each time the button is pressed, the
setting item changes as follows.
Upper: ON
Lower: OFF
The selected settings will take effect.
Press the [EQ/MENU] or [RTN] button
5
to exit sound adjustment mode.

Changing auxiliary input sensitivity

The sensitivity of the auxiliary mode can be changed.
Press the [EQ/MENU] button for
1
more than one second.
The Menu Selection mode is activated.
Press the [SELECT] (Upper/Lower)
2
to select FUNCTION then press the
[ENTER] button.
The function mode is activated.
Press the [SELECT] (Upper/Lower)
3
button to select the AUX SENSE.
The AUX sense mode is activated.
Press the [SELECT] (Upper/Lower)
be
4
button to select the sensitivity mode.
Pressing the button allows you to
toggle through sensitivity modes as
follows:
Low ↔ Mid ↔ Hi ↔ Low ↔
The selected settings will take effect.
Press the [EQ/MENU] or [RTN]
5
button to exit function mode.

Others

XVI
XVII
61